Fujitsu Siemens Computers PRIMERGY R450 System Configurator And Order-information Manual

PRIMERGY R450

System configurator and order-information guide

Contents

Instructions
Configuration diagram
Configurator

0 System software
I Basic unit
II Processor
III Memory
IV Graphics
V Accessible drives
VI Hard disk drives
VII SCSI controller
VIII Disk array
IX Communication/Network
X System Management Products
XI Miscellaneous
XII National accessories packs

Change report

PRIMERGY Server

November 2003

System configurator and order-information guide

PRIMERGY R450 Status 2003-10-24

Instructions

This document contains basic product and configuration information that will enable you to configure your system via

PC-/ System-Architect.

Only these tools will ensure a fast and proper configuration of your PRIMERGY server or your complete

PRIMERGY Rack system.

You can configure your individual PRIMERGY server in order to adjust your specific requirements.

The System configurator is divided into several chapters that are identical to the current price list and PC-/ System-Architect.

Please follow the lines. If there is a junction, you can choose which way or component you would like to take. Go through

the configurator by following the lines from the top to the bottom.

Section

III

Memory, example

There are X memory slots which can be equipped with XXX MB
It is permissible to make up to X passes through the memory upgrade options

S26361-XXX-XXX S26361-XXX-XXX

Memory XXX MB Memory XXX MB

X times

max. X times per system max. X times per system

In one chapter you can only select as many components (here 4x) as the arrow indicates

4x

Please note that there are information symbols which indicate necessary information

Further information in the internet see:

http://www.primergy.com

(internet)

http://extranet.fujitsu-siemens.com/primergy

(extranet)

Prices and availability see price list and PC-/ System-Architect.

Subject to change and errors excepted.

Fujitsu Siemens Computers

Enterprise Products - PRIMERGY Server

2 of 12

System configurator and order-informtion guide

PRIMERGY R450 Status 2003-10-24

Configuration diagram PRIMERGY R450

TOP VIEW

FRONT VIEW

System unit ( I )

Extension slots

Peripheral Bay ( V )

Graphics ( IV )

3.5"x0.5"

LCD

SCSI controller ( VII )

floppy disk

Disk array ( VIII )

Communication/Network ( IX )

Hard Disk Drives ( VI )

2 channels

Channel 1

3.5"x1" 3.5"x1" 3.5"x1"

18PCI-X long 64 Bit / 100 MHz hot-plug

SCSI-ID 0

SCSI-ID 1

SCSI-ID 2

Channel 0

17PCI-X long 64 Bit / 100 MHz hot-plug

3.5"x1"

3.5"x1"

3.5"x1"

SCSI-ID 0

SCSI-ID 1

SCSI-ID 2

26PCI long 64 Bit / 66 MHz hot-plug

Hot-plug power supply 500W ( I )

35PCI-X long 64 Bit / 100 MHz hot-plug

3. PS

2. PS

1.PS44

PCI-X long 64 Bit / 100 MHz hot-plug

Interface: WIDE SCA (80 pins)

53PCI-X long 64 Bit / 100 MHz hot-plug

62PCI long 32 Bit / 33 MHz

61PCI long 32 Bit / 33 MHz

Memory ( III )

The highest assembled bank

is the hot-spare bank,

if the feature is enabled

Processor ( II )

Processors must be plugged

in order according the picture

Xeon MP 3

Xeon MP 4

Xeon MP 2

Xeon MP 1

PCI Bus

Slot

5.25"x0.5"

IDE-drive

Bank 4 (4 modules)

Bank 3 (4 modules)

Bank 2 (4 modules)

Bank 1 (4 modules)

Fujitsu Siemens Computers

Enterprise Products - PRIMERGY Server

3 of 12

System configurator and order-informtion guide

Start "PRIMERGY R450"

PRIMERGY R450 Status 2003-10-24

SW Configurator

with OEM-Software without OEM-Software

for PRIMERGY Server for PRIMERGY Server

Later use of OEM operating system

Microsoft does not allowe software is not allowed,

Vmware-Software the use of OEM-software apart from OEM software by

- ESX Server 1.5 (OEM) under ESX. VMware and F5

- ESX Server 2.0 (OEM)(planned) Distributions-/ retailware is

- Virtual SMP for ESX 2.0 (OEM) allowed.

For all SW products listed below please refer to the corresponding software configurator accessible via the
Extranet under "PC Configurations, Configurator for PRIMERGY SW", URL see below

MS - Software: W **) Novell - Software: ***) PRIMECLUSTER *)

- NT 4.0 Server - NetWare 5.1 - Clustering

- NT 4.0 Server Enterprise Edition - NetWare 6 - Load Balancing

- NT 4.0 Server Terminal Server Edition - NetWare 6.5 (planned)

- Windows 2000 Server - NetWare Cluster Services 1.6 and

- Windows 2000 Advanced Server - NetWare Cluster Services 1.7 Linux - Software: **)

- Windows Server 2003, (planned) with FibreCAT - SuSE Linux Enterprise Server: S
Standard Edition CX200, CX400, CX600 - SuSE Professional Linux
Enterprise Edition - Red Hat Enterprise Linux

- Red Hat Professional Linux

SCO - Software: **)

CITRIX-Software für NT: W1 - UnixWare 7

- Multiuser SW MetaFrame
LoadBalancing
additional User Lizenzen

MultiPath, Duplex Data easy Mirror for Linux
Manager for NT; W2K; Linux NT 4, WIN 2000

FSC System Management

*) Pay attention to release information on datasheet under

Software: V

http://www.primecluster.com

- RemoteView Software

- RemoteView Service Board

- RemoteView Diagnosis **) Pay attention to release and order information in PRINCE -> Operating System

http://vil.mch.fsc.net/vil/pc/vil/primergy/overview/prince/index_en.htm

Backup-Software: U

- ARCserve für NT

***) Supply over distribution or procurement from FSC VP BC Software

You'll find single software configurators and release lists (OS-matrix / system management / security) under following addresses:

for internal users:

http://vil.mch.fsc.net/vil/oec/special/primergy/index_en.htm

for partners:

http://vilpart.fujitsu-siemens.de/vil/oec/special/primergy/index_en.htm

Continue with PRIMERGY
HW configurator

Fujitsu Siemens Computers

Enterprise Products - PRIMERGY Server

4 of 12