Fujitsu siemens DTS-D2764, USD-D2804 Declaration of Conformity

ESPRIMO C

Declaration of Conformity

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:

(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.

Product Type: Personal Computer

Product Name Model

ESPRIMO C5720 DTS-D2764

ESPRIMO C5730 USD-D2804

For the respective Product Name and Model please refer to the printed label on the cover of the
system.

Name of Responsible Party: Fujitsu Siemens Computers Inc.

1250 E. Arques Avenue
Sunnyvale, CA 94085
U.S.A.

Contact Person: Bernd Henning

Phone No.: [phone]
Fax No.: [phone]

We, Fujitsu Siemens Computers Inc., hereby declare that the equipment bearing the respective
trade name and model number specified above was tested conforming to the applicable FCC rules
under the most accurate measurement standards possible, and that all the necessary steps have
been taken and are in force to assure that production units of the same equipment will continue to
comply with the Commissions requirements.

A26361-K1009-Z170-6-7619

1

ESPRIMO C

FCC Class B Compliance Statement

The following statement applies to the products covered in this manual, unless otherwise specified
herein. The statement for other products will appear in the accompanying documentation.

NOTE:

This equipment has been tested and found to comply with the limits for a "Class B" digital device,
pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian Interference­Causing Equipment Standard ICES-003 for digital apparatus. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in strict
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Fujitsu Siemens Computers GmbH is not responsible for any radio or television interference
caused by unauthorized modifications of this equipment or the substitution or attachment of
connecting cables and equipment other than those specified by Fujitsu Siemens Computers GmbH.
The correction of interferences caused by such unauthorized modification, substitution or
attachment will be the responsibility of the user.

The use of shielded I/O cables is required when connecting this equipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC and ICES rules.

2