Fujitsu S26361-F3669-L1 Service Manual

Data Sheet FUJITSU RAID Controller SAS 6Gbit/s 1GB (D3116)

Data Sheet

FUJITSU RAID Controller SAS 6Gbit/s 1GB (D3116)

RAID Controller SAS 6Gbit/s 1GB cache based on LSI MegaRAID® for internal storage devices

The RAID concept (Redundant Array of Independent Disks) refers to several independent hard disks which form a large logical drive when switched together. Redundancy information is calculated from several data blocks (except for RAID 0) and saved distributed to the individual hard disks. Your operating system no longer accesses the individual hard disks, but the array. The actual objective of the RAID concept is to increase availability and prevent downtimes in the event of a hard disk failure. However, the theoretical security of the RAID concept is only as good as

the RAID controller used. Benet from the Fujitsu

RAID controllers where technology, experience and practical implementation all ensure the security that your company needs in the event of an emergency.

RAID Controller SAS 6Gbit/s 1GB (D3116)

The Fujitsu RAID Controller SAS 6Gbit/s 1GB(D3116) with 8 ports sets new speed and data security standards for internal storage drives. The RAID stack is based on the LSI MegaRAID® and offers high data throughput, a comprehensive fault tolerance function and user-friendly management options. Moreover, the Controller management is integrated seamlessly into the Fujitsu server management concept. All controller functions are supported by the Fujitsu ServerView RAID Manager. The RAID Controller SAS 6Gbit/s 1GB (D3116) is designed for backward compatibility with 3Gbit/s

SAS as well as with 6Gbit/s and 3Gbit/s SATA hard drives. Regardless of the drive speed, it delivers

signicant performance improvements in both

read and write applications. Due to the support of 64-bit addressing, a robust set of RAID features and demanding error tolerance functions the controller provides high RAID performance and data availability. Powerful online management service programs (Fujitsu ServerView RAID Manager), which are simple to operate and quick to install, provide the administrator with unparalleled

exibility and access to the arrays. The RAID

controller supports all of the important RAID levels

including RAID 6 and 60. The optional ash battery

backup (FBU) combined with TFM module ensures the integrity of the data stored in the cache on the RAID controller in case of a power outage. In this event, the data will be copied to a non-volatile

ash memory (TFM). The FBU provides a low-priced

alternative to an uninterruptible power supply (UPS) and, when compared to battery backup up units (BBU), enables a long-term, secure store of data and better serviceability. Always select FBU and TFM module in combination.

Main Features Benefits

 6Gbit/s SAS ports PCI Express® 2.0 x8  Connect up to 32 HDDs and SSDs  LSISAS2208 6Gbit/s RAID-on-Chip  RAID levels 0, 1, 5 and 6 for more data security

 1GB 1333MHz DDRIII cache memory  RAID spans 10, 50 and 60 for more data security  Optional Flash Backup Unit (FBU)  Ensures the integrity in case of power outage

 Long-term, secure store of data and better serviceability compared

to BBU

 User Management Options  Seamless merging of the RAID management into system

management

Page 1 / 4 www.fujitsu.com/primergy

Data Sheet FUJITSU RAID Controller SAS 6Gbit/s 1GB (D3116)

Technical details

Controller Silicon RoC (RAID on Chip) LSI SAS2208 Controller type RAID 5/6 Ctrl. Operating system Information to released operating systems can be found in the server datasheets. Details can be found in the

released drivers list on the support portal.

Released drivers list link http://support.ts.fujitsu.com/Download/Index.asp Number of ports 8 ports int. Connector internal 2x SSF-8087 Data transfer rate up to 6 Gbit/s Bus type PCIe 2.0 Bus width x8 RAID Management ServerView RAID Manager

MegaCLI (command-line interface) WebBIOS

Key RAID Data Protection Feature - RAID levels 0, 1, 5 and 6

- RAID spans 10, 50 and 60

- Online Capacity Expansion (OCE)

- Online RAID level Migration (RLM)

- Auto resume after loss of system power during array rebuild or reconstruction (RLM)

- Fast initialization for quick array setup

- Single controller multipathing (failover)

- Load Balancing

- Congurable stripe size up to 1MB

- Fast initialisation for quick array setuo

- Check consistency for background data integrity - Make Data Consistent (MDC)

- Patrol read for media scanning and repairing

- Up to 64 logical drives per controller

- Up to 64TB LUN support DDF-compliant

- S.M.A.R.T support

- Global and dedicated Hot Spare with Revertible Hot Spare support

- Automatic rebuild

- Enclosure afnity

- Enclosure management

- SES (inband)

- SGPIO (outband)

RAID level 0, 1, 10, 5, 50, 6, 60 RAID cache backup unit Optional FBU RAID controller notes (based on LSI SAS2208) Interface technology SAS/SATA

Order code Product Name Height of bracket RAID controller cache size Number of Connectors

S26361-F3669-E1 RAID Ctrl SAS 6G 1GB (D3116) Matching to system 1 GB 2 S26361-F3669-E2 RAID Ctrl SAS 6G 1GB (D3116) Matching to system 1 GB 2 S26361-F3669-L1 RAID Ctrl SAS 6G 1GB (D3116) Full Height / Low Prole 1 GB 2 S26361-F3669-L2 RAID Ctrl SAS 6G 1GB (D3116) Full Height / Low Prole 1 GB 2

Order code Product Name Notes

S26361-F3669-E125 RAID Ctrl FBU option with 25cm cable installed - Super-capacitor incl. cable S26361-F3669-E155 RAID Ctrl FBU option with 55cm cable installed - Super-capacitor incl. cable S26361-F3669-E170 RAID Ctrl FBU option with 70cm cable installed - Super-capacitor incl. cable S26361-F3669-L110 FBU option with 25/55/70 cm cable loose delivery - Super-capacitor incl. cables for all systems S26361-F3669-E100 TFM Module for FBU option on D3116 installed - Transportable Flash Module - contains ash memory

and control logic for Flash Backup Unit (FBU) – required for FBU option

Page 2 / 4 www.fujitsu.com/primergy

+ 2 hidden pages