Page 1
58-0578-01.fm Page 1 Tuesday, August 21, 2001 2:52 PM
Fujitsu PC Corporation
Screen Protector
Installation Guide
FMWSP11 / FPCSP01
INSTRUCTIONS
This screen protector is designed for use on the Stylistic LT
C-500 and Stylistic LT P-600 pen tablet display screens.
Notes
• Before installing a new screen protector, remove any
screen protector that is already installed. Check to see
which corner of the screen protector is not glued to the
surface of the display; ordinarily, it will be the bottom
left corner. A notch in the corner allows you to slide a
firm, pliable implement (such as a credit card) under
the screen protector for removal. Do not use a metal
implement; it could scratch the screen.
• To ensure good adhesion, clean the screen with a soft
cotton cloth dampened with isopropyl alcohol before
installing the screen protector. When the alcohol dries,
it may leave streaks on the screen. If streaking occurs,
buff the screen gently with a clean, dry cloth.
Page 2
58-0578-01.fm Page 2 Tuesday, August 21, 2001 2:52 PM
Installation Instructions
Note
An adhesive band secures the screen protector to the
protective strip around the entire perimeter except for
one corner. Hold it up to a light to see which corner does
not have the adhesive strip. (See Figure 1).
1. Peel the protective film from the adhesive side of the
screen protector, as shown in Figure 1.
Adhesive
strip
No Adhesive
Figure 1. Peeling Protective Film
2. Install the screen protector on the pen tablet display
screen. Apply the adhesive side to the screen with the
glueless corner in the lower left, as shown in Figure 2.
3. Apply pressure along the edges of the screen protector
with your finger. (Avoid lifting the screen protector
from the screen after installation. The adhesive requires
48 hours to cure properly.)
2
Page 3
58-0578-01.fm Page 3 Tuesday, August 21, 2001 2:52 PM
4. Remove the protective film from the top of the screen
protector, as shown in Figure 3.
5. Wipe the exposed surface of the screen protector with a
clean dry cloth to remove any adhesive left behind by the
protective film.
Figure 2. Installing the Screen Protector
Figure 3. Removing the Protective Film
3
Page 4
58-0578-01.fm Page 4 Tuesday, August 21, 2001 2:52 PM
5200 Patrick Henry Drive
Santa Clara, CA 95054
For more information, visit our Web site
at: www.fujitsupc.com
For technical support call:
1-800-8Fujitsu (1-800-838-5487)
or e-mail us at: 8fujitsu@fujitsupc.com
Fujitsu and the Fujitsu logo are registered trademarks of Fujitsu, Ltd. Stylistic is a
trademark of Fuji tsu PC Corporation. All other t rademarks mentioned herein are th e
property of their respective owners. We cannot guarantee the accuracy of the contents of
this document. We disclaim liability for errors, omissions or future changes.
© 2001 Fujitsu PC Corporation. All rights reserved. FPC58-0578-01
B5FY-1621-01EN-00
4
Loading...