Fujitsu FPCCC27P, FPCCC27 User Manual

Fujitsu Computer Systems

Harsh Environment Case
User’s Guide

FPCCC27/FPCCC27P

INSTRUCTIONS

These instructions provide details on using the FPCCC27/
FPCCC27P Harsh Environment Case (HEC). The FPCCC27
HEC is designed for use with your Stylistic ST4000 Tablet
PC (with active digitizer); the FPCCC27P HEC is designed
for use with your Stylistic ST4000P Tablet PC (with passive
digitizer). The HEC provides maximum protection against
water, dust, and other hazards when transporting, using, or
storing the Tablet PC.

We strongly recommend that you read these instructions
prior to using the HEC with your computer.

Note the following when using the HEC:

• To avoid overheating, suspend the Tablet PC when
charging the battery pack while the system is in the case
and not in use.

• To prevent scratches, a screen protector should be
installed on the display window of the HEC. Two screen
protectors are provided with the HEC. Additional
screen protectors can be obtained from your reseller, or
from the Fujitsu Web site at: us.fujitsu.com/computers.

• If you use the Tablet PC both with and without the
HEC, a screen protector can be left in place on the
system. If the system will be used only in the HEC,
remove the screen protector on the system for better
viewing.

• If you use a pen tether, attach it to one of the D-rings
on the back of the case.

Pen holder

Status LED window

Infrared
port access

Navigation

button access

IR keyboard

port access

Application
button access

Power On/
Suspend/

Resume/

button

Figure 1. Tablet PC HEC - Front

2

Installing the Tablet PC in the HEC

To install your Tablet PC into the HEC, position the case
face down as shown in Figure 2. Open the top flap. The top
flap is secured by a long strip of Velcro® that is attached to
the back of the HEC. Unzip the two side flaps.

Top Flap

D-Rings
(4 places)

Figure 2. Tablet PC HEC - Rear

Hand
straps

Side FlapSide Flap Velcro strips

Lay the system face down into the case, with the screen
facing the open window. (See Figure 3). Zip up the side flaps
and close the top flap

3