Fujitsu FMW43SA1 User Manual

SerialAdapter.fm Page 1 Monday, August 27, 2001 9:03 AM
Fujitsu PC Corporation
Serial Adapter (DB9) Installation Guide
FMW43SA1
For use with Stylistic
INSTRUCTIONS
The serial adapter allows you to connect a serial device directly to your pen tablet without a docking device. The port is a fully functional RS-232C serial port that can be used as a standard se rial port on your pen tablet.
On one side of the adapter is a plug which fits into the system interface port (see Figure 1). On the opposite side of the adapter is a 9-pin port for a serial connector (see Figure
2). To install the adapter,
T M
LT Pen Tablet PCs
1. If the pen tablet is running, either suspend operation or power down the system.
2. If the serial device you wish to connect has power applied, remove power.
SerialAdapter.fm Page 2 Monday, August 27, 2001 9:03 AM
3. Remove the plastic cover that is located over the system interface port on the bottom edge of the pen tablet. Keep the cover in a safe place for future reinstallat i on.
4. Plug the serial adapter into the system interface port. The plug is keyed so that it will only fit when it is posiĀ­tioned properly (see Figure 3).
5. Insert the serial plug into t he serial c onnect or (see Figure
2).
6. Restart the system and the serial device.
To remove the adapter,
1. If the pen tablet is running, either suspend operation or power down the system.
2. If the serial device you wish to disconnect h as power applied, remove power.
3. Pull the plug from the connector. Replace the plastic cover over the system interface port.
4. Restart your syst em .
Note: When the serial adapter is attached to the pen tablet,
the tablet cannot be used in the compact desk stand because the connector/cable assembly extends too far from the bottom of the system. The system should be held or laid flat when the serial adapter is installed.
2
Loading...
+ 2 hidden pages