Fujitsu FMW42RC1 INSTALLATION

FMW42RC1
Radio Antenna Cover Kit
Installation Guide
Stylistic 3400
These instructions provide details on ass embling and installing the Radio Antenna Cover Kit for the Stylistic 3400 pen tablet.
The antenna cover should be installed when most types of antennae protrude from a r adio PC Card. The cover provides a rigid cap over the antenna to prevent damage during everyday use.
Note
The antenna cover was specifically tested with Symbol®, ProximTM, BreezeComTM, and AiroNet possible that certain other antennae will protrude too far from the system to fit within the antenna cover.
Assembling th e R ad io Antenna Cover Kit 0
The Radio Antenna Cover Kit consists of the following parts:
•Plastic Hood
TM
radios; it is
FUJITSU PC CORPORATION
3. Insert the antenna cover tabs into the two tab slots on the pen tablet.
4. Insert the two black screws through the holes in the hood and secure them to the pen tablet.
Hood
Standoff
Positioning Tab (inside)
Base
Tapping Scre w
• Plastic Base
•Two black screws
• One tapping screw
To assemble the radio antenna cover, place the hood atop the base as illustrated in Figure 1. Make sure the positioning tab is on the inside of the hood. Secure the two pieces with the tapping screw by inserting it through the hole in the base into the standoff insi d e the hood.
Installing the Radi o A nte nn a C over 0
To attach the radio antenna cover to the pen tablet, perform the following steps.
1. Position the antenna cover in relation to the back of the pen tablet as shown in Figure 2.
2. If caps are present over the mounting holes, remove them with a small screwdriver, or similar tool.
Figure 1. Assembling the Radio Antenna Cover
Tab Slots
Mounting Hole
Tab
PC Card Slot
Figure 2. Installing the Radio Antenna Cover
Symbol®, ProximTM, BreezeComTM, and AiroN etTM are trademarks or registered trademarks of their respective companies.
Stylistic 3400 is a trademark of Fujitsu PC Corporation. © 2000 Fujitsu PC Corporation
Loading...