Fuji Film 03000008 User Manual

FUJIFILM Corporation

Power Supply

3.3V Supply Voltage

Operating Temperature

0 – 50° C ambient temperature

5 to 90 % (non-condensing)

Storage Temperature

-20 ~ 70°C ambient temperature

5 to 95 % (non-condensing)

Interface

UART

Operating Frequency

2402MHz ~ 2480 MHz

BM-8761ATT

BT Module

Specifications

※本製品を搭載する際に各ピンの説明書をご参照ください。
※Please refer to the manual of each pin when installing this product。

FCC

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one of the

following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to operate this

equipment.

This transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

Radiation Exposure Statement:

The product comply with the FCC portable RF exposure limit set forth for an

uncontrolled environment and are safe for intended operation as described in

this manual. The further RF exposure reduction can be achieved if the product

can be kept as far as possible from the user body or set the device to lower

output power if such function is available.