Page 1
FCC ID:SL9NLS-NQUIRE1000
NLS-NQuire1000 is a stationary device.
Chipset
Memory
Storage
LCD Panel
Sensor
Connector
Slot
Chipset Rk3368
DDR3
eMMC
2GB
8GB
LCD Size 1 0. 1"
Resolution 1280 800*
TFT IPS
G-Sensor
Earphone
Jack
YES
Φ3.5mm
2
3 4 5 6
1
17
8 9
11 13 15
7
10 12 14 16
Nquire1000
Speaker
Expansion port
Built-in 8Ω/1.5W speaker x2
POGO-PIN x2,USB 2.0
Card interface SD Card
Type A USB 2.0 HOST
Interface
WiFi
Bluetooth
Scanning
head
DC-IN
Micro USB 2.0 OTG RS232 Interface
WiFi 802.11 b/g/n+a/n/ac(5G)
BT4.1
Support USB interface/ mipi
interface/ 12C interface
3.5mm DC-IN 12V/2A
Camera
SD card
Up/Downkey
Scanner
Pogo pin 2
LAN
13
micro USB 2.0 DC-IN
15
Power button
17
Earphone jack
12
14
16
LED
Exit key
Vol+/Vol- key
Pogo pin 1
Speaker 1
USB Type A
Speaker 2
Page 2
Page 3
FCC caution
Federal Communication Commission (FCC) Radiation Exposure Statement
When using the product, maintain a distance of 20cm from the body to ensure compliance
with RF exposure requirements.
FCC statements:
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications or changes to this equipment. Such
modificationsorchangescouldvoidtheuser’sauthoritytooperatethe
equipment.
NOTE:Thisequipmenthasbeentestedandfoundtocomplywiththelimitsfora
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residentialinstallation.Thisequipmentgeneratesusesandcanradiateradio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
‐ Reorient or relocate the receiving antenna.
‐ Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
‐Consult the dealer or an experienced radio/TV technician for help.
Loading...