Page 1
LIT1679 WM-UTR1S Short Under Table Rack Installation Instructions
FSR
INSTALLATION AND WIRING OF ELECTRONIC COMPONENTS (SOLD
SEPARATELY) CAN BE DONE DURING OR AFTER INSTALLATION.
1.
INSTALL COVER TO UNDERSIDE OF DESK, TABLE, COUNTER,
ETC. KEEP BACK EDGE OF COVER 1.50" AWAY FROM ANY
VERTICAL SURFACE.
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
TABLE
TABLE
COVER
2. INSTALL ELECTRONIC COMPONENTS AS REQUIRED TO CHASSIS
(ELECTRONIC COMPONENTS CAN BE INSTALLED AT A LATER
DATE). RACK RAILS CAN BE MOVED TO VARIOUS LOCATIONS OR
REMOVED AS NEEDED. HANG CHASSIS FROM COVER AS SHOWN.
COVER
1.50
(13) #6 x 1/2" LONG TYPE AB
PAN HEAD SCREW (OR
ALTERNATE HARDWARE
SOLD SEPARATELY)
INSTALLED COVER
COVER
CHASSIS
43282 LIT1679
CHASSIS ANGLE MUST BE
GREATER THAN 30° TO
HANG/REMOVE FROM COVER
OPENING FOR
CABLES AND WIRES
ON BOTH SIDES
RACK RAIL
RACK RAIL
CHASSIS
SECONDARY LATCH
Page 2
3.
TO CLOSE UNIT LIFT CHASSIS UP TO COVER. SECONDARY LATCH WILL
PREVENT CHASSIS FROM CLOSING INTO COVER. SQUEEZE SECONDARY
LATCH TO COMPLETELY CLOSE UNIT AND LOCK CHASSIS IN PLACE BY
ROTATING KEY LOCK TO CLOSED POSITION.
4.
TO OPEN UNIT ROTATE KEY LOCK TO OPEN POSITION. SECONDARY LATCH
WILL PREVENT CHASSIS FROM DROPPING OPEN. SQUEEZE SECONDARY
LATCH TO COMPLETELY OPEN UNIT. OPEN SLOWLY TO AVOID DAMAGE TO
ELECTRONIC COMPONENTS. CHASSIS CAN BE REMOVED FROM COVER TO
SERVICE COMPONENTS.
KEY LOCK
COVER
CHASSIS
1.50
KEEP AREA CLEAR
FOR CHASSIS TRAVEL
KEY LOCK
MOVE SECONDARY LATCH
IN DIRECTION INDICATED
TO OPEN/CLOSE UNIT
SECONDARY LATCH DETAIL
SECONDARY LATCH
ROTATE
CLOCKWISE
TO CLOSE
KEY LOCK DETAIL - OPEN POSITION
ROTATE
COUNTER-
CLOCKWISE
TO OPEN
KEY LOCK DETAIL - CLOSED POSITION
Loading...