Page 1
4a.
PUSH WIREWAY UP TO MOUNTING BRACKET UNTIL IT STOPS.
4b.
PUSH PLATE WITH STANDOFFS TOWARDS TONGUE SO THAT
WIREWAY WILL HANG UNASSISTED.
4c.
TIGHTEN SCREWS TO SECURE WIREWAY TO MOUNTING
BRACKET.
HOOK
LOOP
5.
INSTALL AND ROUTE ALL WIRING AS DESIRED/NECESSARY,
BEFORE CLOSING AND LATCHING THE SIDES OF THE WIREWAY
(WIRING CAN ALSO BE INSTALLED AT A LATER DATE).
6. WITH WIREWAY CLOSED, INSTALL BOOT HALVES AND SLIDE
DOWN TO MEET FLOOR. REMOVE "LOOP PAD" FOR CARPETED
FLOORS, AND REMOVE JUST THE ADHESIVE PROTECTOR FOR
NON-CARPETED FLOORS.
WM-CMPT Installation Instruction
FSR
1. WIRING CAN BE DONE DURING OR AFTER INSTALLATION. SEE CUSTOMER
SPECIFICATIONS FOR LOCATING WM-CMPT. ORIENT AS REQUIRED SO THAT
THE WIREWAY AND WIREWAY OPENING IS BEST ACCESSED FOR
SERVICABILITY. ENSURE WIREWAY DOORS ARE NOT OBSTRUCTED.
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
TO TABLE
UNDERSIDE
MOUNTING BRACKET
ADHESIVE
PROTECTOR
a.
c.
b.
OPENING TO WIREWAY
TONGUE
LABEL ON OTHER SIDE
INDICATING WIREWAY
MOUNTING SIDE
TUBE WIREWAY
SHOWN OPEN
GROOVE ON WIREWAY
(2) BOOT HALF
ALIGN GROOVE IN BOOT
WITH GROOVE ON WIREWAY
43246 LIT1667
Page 2
INSTALL MOUNTING BRACKET TO UNDERSIDE OF
2. OPEN TUBE WIREWAY AND INSTALL MOUNTING PLATES AS SHOWN.
TABLE AS SHOWN.
TABLE
3.
THREAD THE SCREWS IN ONLY 1/8" SO THAT THE WIREWAY CAN BE
INSTALLED ONTO TONGUE.
TUBE WIREWAY
SHOWN OPEN
PLATE WITH
STANDOFFS
PLATE
(2) #8-32 x 3/8 LONG
PAN HEAD SCREW
MOUNTING BRACKET
REMOVABLE SERVICE LOOP
SUPPORT PLATFORM
(4) .172 DIA MOUNTING HOLE
UNDERSIDE OF
MOUNTING BRACKET
3.00
TONGUE
3.25
(4) #6 x 1/2 LONG TYPE AB
PAN HEAD SCREW
NOTCHES TO ASSIST
IN CENTERING BRACKET
WITH CHALK LINES
TONGUE
TONGUE SIDE
ONLY THE #8-32
HARDWARE CAN
PASS THRU SLOTS
TONGUE SIDE
OR
REMOVABLE SERVICE LOOP
SUPPORT PLATFORM
Loading...