FSR T3-IPS User Manual

T3-IPS INSTALLATION INSTRUCTIONS

FSR

1.

DRILL 3.50" DIAMETER HOLE IN TABLE TOP.

2.

INSERT T3 ASSEMBLY AND ORIENT AS REQUIRED.

3.

INSTALL MOUNTING CLAMPS TO ASSEMBLY AND SECURE TO TABLE BY
SCREWING MOUNTING SCREWS TO UNDERSIDE OF TABLE.

4.

MAKE ELECTRICAL CONNECTIONS AS REQUIRED.

244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: [phone] - Fax: [phone]

T3 ASSEMBLY

MOUNTING

CLAMP AND

MOUNTING

SCREW

INSTALLED

CUSTOMER TO PROVIDE

KO SLUG/PENNY/OTHER

HARD FLAT PIECE FOR

SCREW END, WITH SOFT

TABLE WOOD

MOUNTING

CLAMP AND

MOUNTING

SCREW

(SEE BELOW)

3.50" DIAMETER

MODEL ILLUSTRATED

MAY DIFFER FROM

MODEL PURCHASED

TABLE

SLOTS USED FOR 5/8" TO
1-1/8" THICK TABLE TOPS

SLOTS USED FOR 1-1/8" TO
1-9/16" THICK TABLE TOPS

(2) MOUNTING

CLAMP

(2) MOUNTING

SCREW

43071 LIT1518A

T3-IPS TABLE BOX WIRING PINOUT
FOR ONE AND TWO BUTTON / LED MODELS

SWITCH / LED PC BOARD

6’ WIRE TAILS

CONTROL LEADS

ONE BUTTON / ONE
LED MODELS

ADDITIONAL COMPONENTS
FOR TWO BUTTON / TWO
LED MODELS

POLE

GRN / RED SWITCHED LED +

6’ WIRE TAILS

CONTROL LEADS

POLE

GRN / RED SWITCHED LED +