FSR T3-DV2S User Manual

T3-DV2S / T3-PC1D INSTALLATION INSTRUCTIONS

FSR

1.

INSTALL SHROUD TO UNDERSIDE OF TABLE HOLE WITH WOOD SCREWS
AS SHOWN. ORIENT PER DESIRED COVER SWING DIRECTION.

2.

MAKE ELECTRICAL CONNECTIONS AS REQUIRED AND ENSURE
WIRES PASS THRU PROPER OPENINGS IN THE SHROUD. DROP THE
T3 ASSEMBLY INTO THE HOLE (COVER ORIENTATION IS PRE-SET BY
SHROUD INSTALLATION).

3.

PASS THE DESIRED-LENGTH (2) LONG THREADED ROD THRU SHROUD
AND THREAD INTO T3 ASSEMBLY. TURN THE LOCKING NYLON NUT UP
SNUG AGAINST THE SHROUD BASEPLATE TO PULL THE T3 ASSEMBLY
DOWN COMPLETELY INTO PLACE IN THE TABLE HOLE.

4.

TIE WRAP CABLES TO THE TAB(S) PROVIDED ON SHROUD.

244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: [phone] - Fax: [phone]

MODEL ILLUSTRATED

MAY DIFFER FROM

MODEL PURCHASED

1.00" MIN TO

THICKNESS

(3/4" MIN FOR

NO-BUTTON

T3 ASSEMBLY

2-1/2" MAX

TABLE

MODEL)

PRE-CUT

3.50" DIA
HOLE IN
TABLE

ASSEMBLED VIEW

#6 / #8 MOUNTING HOLES
TRANSFER HOLES FROM
SHROUD TO TABLE

3.50" DIA

THRU TABLE

UNDERSIDE VIEW OF SHROUD

CABLE TIE TAB

SHROUD

MODEL ILLUSTRATED

MAY DIFFER FROM

MODEL PURCHASED

#6 / #8 x 1/2"

WOOD SCREW

(2) LOCKING NYLON NUT

(2) #6-32 x 2.00" or 3.00" LONG

THREADED ROD

43072 LIT1519B

T3-PC1D / T3DV2S TABLE BOX WIRING PINOUT
FOR ONE AND TWO BUTTON / LED MODELS

SWITCH / LED PC BOARD

INTERCONNECT PC BOARD

(T3-PC1D ONLY)

CAPTIVE SCREW TERMINALS

ONE BUTTON / ONE
LED MODELS

ADDITIONAL COMPONENTS
FOR TWO BUTTON / TWO
LED MODELS

POLE

CAPTIVE SCREW TERMINALS

POLE