FSR T3-AC2CP User Manual

T3-AC2CP

INSTALLATION

INSTRUCTIONS

FSR

1.00" MIN. TO 2-1/2" MAX.
TABLE THICKNESS

PRE-CUT 3.50" DIA.

HOLE IN TABLE

244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: [phone] - Fax: [phone]

T3-AC2CP
SUB-ASS'Y

ASSEMBLED VIEW

4.25

2.13

#6 / #8 MOUNTING
SCREW HOLES

(5) CABLE
TIE TAB

(6) #6 / #8 x 1/2"

WOOD SCREW

(2) LOCKING NYLON NUT

(2) #6-32 x 2.00" or 3.00" LONG

THREADED ROD

7.50

2.13

1.63

3.25

UNDERSIDE VIEW OF SHROUD

DROP THE 'T3-AC2CP' SUB-ASS'Y

2

INTO THE HOLE IN THE TABLE
(COVER ORIENTATION IS PRE-SET
BY THE SHROUD INSTALLATION).

INSTALL CLAMP SHROUD TO UNDERSIDE

1

OF TABLE HOLE WITH (6) WOOD SCREWS
AS SHOWN. ORIENT PER DESIRED
COVER SWING DIRECTION.

PASS THE DESIRED-LENGTH (2) LONG

3

THREADED ROD THRU THE SHROUD AND
THREAD INTO SHORT STANDOFFS IN THE
SUB-ASS'Y. TURN THE LOCKING NYLON NUT
UP SNUG AGAINST THE SHROUD BASEPLATE
TO PULL THE SUB-ASS'Y DOWN COMPLETELY
INTO PLACE IN THE PRE-CUT 3.50" DIA. HOLE.

MAKE ELECTRICAL CONNECTIONS AS

4

REQUIRED AND TIE-WRAP CABLES TO
TIE-TABS. ENSURE CONNECTORS IN THE
SUB-ASS'Y CAN BE PULLED OUT 3'-0"
PRIOR TO SECURING CABLES TO TIE TABS.

5.50

3.25

1.63

3.50" DIA. THRU
HOLE ON TABLE

43169 LIT1285A