FSR SYM-IN Installation Instructions Manual

SYM-IN Installation Instructions

FSR

1.

SELECT LOCATION FOR ASSEMBLY AND CUT APPLICABLE HOLE
IN TABLE. INSERT ASSEMBLY INTO HOLE AND PUSH DOWN ON
FLANGES. TO REMOVE ASSEMBLY FROM TABLE, PRY BOTTOM
OF CAPTURE SPRING OFF ASSEMBLY FRAME.

244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: [phone] - Fax: [phone]

HOLE CUT OUT

SHARP TO 3/16" MAX

RADIUS CORNERS

TYPE FLANGE SIZE

ASSEMBLY

CUT OUT SIZE

CUT OUT

SIZE

FLANGE

SIZE

5.00"

TABLE

A FRAME
B FRAME
C FRAME
D FRAME

6.30"

7.73"

8.69"

10.12"

6-1/16"
7-7/16"
8-7/16"

9-7/8"

CAPTURE SPRING

TO REMOVE ASSEMBLY, INSERT
SCREWDRIVER THRU OPENING AND
PRY BOTTOM OF CAPTURE SPRING
OUT OF ASSEMBLY FRAME LIP, BOTH
SIDES. LIFT ASSEMBLY OUT OF HOLE
TO COMPLETE REMOVAL.

43346 LIT1728

2.

IF APPLICABLE, INSTALL KEYSTONE CONNECTORS (SOLD SEPARATELY) INTO
INSERTS (SINGLE OR DUAL), MAKE WIRING CONNECTIONS AS REQUIRED, AND
INSTALL INSERTS INTO ASSEMBLY. IF KEYSTONE CONNECTORS ARE TO BE
INSTALLED AT A LATER DATE INSTALL BLANK INSERTS. FRONT FACE MUST BE
CLOSED WITH KEYSTONE OR BLANK INSERTS.

INSERT INSTALLATION AND REMOVAL

a.

TO INSTALL, PUSH INSERT WHERE INDICATED,
SNAPPING INSERT INTO ASSEMBLY.

PUSH HERE

b.

INSERT SCREWDRIVER HERE

PUSH HERE

INSERT SCREWDRIVER HERE

TO REMOVE, INSERT SCREWDRIVER WHERE
INDICATED, PRYING INSERT OUT OF ASSEMBLY.