FCL0001 Cabinet Lock
Installation Instructions
The cabinet lock is designed to fit into cabinets and lockers with swing or sliding doors. The
lock is interchangeable between the POWER TO LOCK (see FIG 1) and POWER TO OPEN
(see FIG 2), two kinds of operation modes.
Striker installation:
SIDE ENTRY OF STRIKER (see FIG 3) Use the 10mm distance indicated in Figure 4 to set
the distance from the interior side of the door to the
first screw hole of the lock.
FRONT ENTRY OF STRIKER (See FIG 3) Use the 37mm distance indicated in Figure 4 to set
the distance from the backside of the lock to the
mounting face of the striker.
Power input 12 VDC or 24 VDC supply:
Note: There is no polarity on power input.
RED
BLUE
12 VDC / 190 mA
YELLOW
BLACK
RED
BLUE
24 VDC / 90 mA
YELLOW
BLACK
Figure 1: PTL
Interchange between PTL and PTO:
1 Remove four screws from bottom
2 Remove the bottom case
3 Replace the wire in opposite side
4 Turn the bottom case 180o horizontally
5 Replace the bottom case
6 Replace the four screws.
Figure 2: PTO
SIDE ENTRY SIDE ENTRY SLIDE ENTRY
Striker in sert
from le ft
10
10
Striker inse rt
from rig h t
FIG 3
FRONT ENTRY
Striker can enter lock from
any of three sides, and also
sliding from the side.
FIG 4
Striker in sert fro m fron t
Figure 3 Figure 4
22
￠
3.8CSK-4HOLES
SLIDING DOORS
1
FIT DOOR LOCK FIRST
2
22
15.5
60
15.5
40
72.7
4.5
31
SWING DOORS
1
FIT DOOR LOCK FIRST
2
Min 20Min 20
15.5 15.5
FIT STRIKER SECOND
FIT STRIKER SECOND
V1.0 2008
Loading...