FSC SKOP Operation & Maintenance Manual

Factory Furniture Ltd | The Stableyard | Coleshill | Swindon SN6 7PT | T [phone] | F [phone]

[e-mail] | www.factoryfurniture.co.uk

We reserve the right to change specification without notice. © 2008 Factory Furniture Ltd

FSC

TM

- The mark of responsible forestry. ©1996 Forest Stewardship Council A.C.

SKOP bench, seat & stool

Operation & Maintenance Manual

Introduction

Design

Design, shop drawings and development by Factory Furniture Ltd

Manufacture

Factory Furniture manufactured components. Products are assembled in Factory workshops, checked and dispatched ready
for installation. Replacement products or components thereof should be ordered direct from Factory Furniture Ltd

Copyright

The design copyright for the product and drawing copyright remains the sole property of Factory Furniture Ltd

General Specifications

Bench Seat (with back)
Metric length 2500mm | width 620mm | height 450mm Metric length 2500mm | width 620mm | height 860mm
Imperial length 8’ 2½” | width 2’ ½” | height 1’ 5½” Imperial length 8’ 2½” | width 2’ ½” | height 2’ 10”

Approx Weight 72kg Approx Weight 84kg

Fixing Centres 2420mm (7’ 11½”) x 420mm (1’ 4½”)

Stool

Metric length 580mm | width 620mm | height 450mm
Imperial length 1’ 11” | width 2’ ½” | height 1’ 5½”

Approx Weight 27kg

Fixing Centres 500mm (1’ 7½”) x 420mm (1’ 4½”)

Detailed Material & Finish Specifications

Seat Slats

• Manufactured from FSC certified tropical hardwood or non-FSC oak (other timber options available upon request)

• Profiled and left untreated as standard (oil or microporous woodstain treatment available on request)

• Supported on frame - attached with 4 no. fixing points each

Back Rest (Skop ‘seat’ only)

• Slats are manufactured from FSC certified tropical hardwood or non-FSC oak to match seat slats (other timber options
available upon request).

• Slats are profiled and left untreated as standard (oil or microporous woodstain treatment available on request). Each slat is
attached to the back frame via 2 no. fixing points. Each back panel has 4 no. slats

• Back rest frame manufactured from stainless steel angle - satin polished or polyester powder coated (powder coat colour
grey as standard or to customer specification). Each back support is fixed to the seat top via 4 no. fixing points

Frame

• Manufactured from stainless steel rectangular section tubing - satin polished or polyester powder coated finishes (powder
coat colour grey as standard or to customer specification)

• Anchored using 2 no. resin fixed M10 x 200mm threaded rods and cap nuts per base (surface fix only)

2SKOP specification