Fryette G-2902-S Owner's Manual

TWO/NINETY/TWO STEREO POWER AMPLIFIER

MODEL G-2902-S

OWNERS MANUAL

FRONT PANEL

LEFT TO RIGHT

1. VOLUME - Level control for Channel A.

2. LEVEL

3. PRESENCE

4. VOICING

5. DEPTH

6. VOLUME

7. LEVEL

8. PRESENCE

9. VOICING

10. DEPTH

11. STANDBY

12. FAN SPEED

- Push button switch for controlling input si gnal level; Out = -10 dB, In = 0dB.

- Increases high frequency gain.

- Push button switch. Extends low-mid and high frequencies

- Variable damping for extended low f requency and l ooser spea ker respon se.

- Level control for Channel B

- Push button switch for controlling input signal level; Out = -10dB, In = 0dB

- Increases high frequency gain.

- Push button switch. Extends low-mid and high frequencies

- Variable damping for extended low f requency and l ooser spea ker respon se.

- In standby, the amplifier output is disabled while power is supplied to the tube filaments only. Use

STANDBY instead of the power switch during breaks to extend tube life and avoid the warm-up delay.

- Up = Full speed. Use when operating amplifier at full po wer. Down = Slow spe ed. Use when

operating the amplifier in Low Power mode or whe n quiet operation i s required.

13. HIGH/LOW POWER
channel operates at 60W per channel.

14. FUSE

15. MAINS

z Page 2

- 1 amp fast blow fuse for protection of individu al channels.

- Sw i t c h e s m a i n A C p o w e r o n o r off. Illuminates when the unit is ON. You can extend the life of the

amplifier tubes by keeping the STANDBY (V) switch down for the first 60 seconds that the power i s ON.

– In High Power mode, each channel operate s at 98W per ch annel. In Low Power mode, each