TWO/FIFTY/TWO STEREO POWER AMPLIFIER
MODEL G-2502-S
OWNERS MANUAL
FRONT PANEL
LEFT TO RIGHT
1. VOLUME - Level control for Channel A.
2. LEVEL
3. PRESENCE
4. VOICING
5. DEPTH
6. VOLUME
7. LEVEL
8. PRESENCE
9. VOICING
10. DEPTH
11. CLASS A/AB
12. STANDBY
- Push button switch for controlling input si gnal level; Out = -10 dB, In = 0dB.
- Increases high frequency gain.
- Push button switch. Extends low-mid and high frequencies
- Variable damping for extended low f requency and l ooser spea ker respon se.
- Level control for Channel B
- Push button switch for controlling input si gnal level; Out = -10d B, In = 0dB
- Increases high frequency gain.
- Push button switch. Extends low-mid and high frequencies
- Variable damping for extended low f requency and l ooser spea ker respon se.
- Up = Class AB power tube operatio n (62 watts/ch annel). Down = Class A (Cathode Bias) power tube
operation (50 watts/channel).
- Turns on high voltage to output section. In stand by, the amplifier output is disabled while power is
supplied to the tube filaments only. Use STANDBY instead of switching the power off during short breaks to
extend tube life and avoid the warm-up delay upon returning to play.
13. FUSE A
14. FUSE B
15. MAINS
tubes by keeping the STANDBY (V) switch down for the first 60 seconds that the power is ON.
z Page 2
- 1/2 amp fast blow fuse for Channel A
- 1/2 amp fast blow fuse for Channel B
- Sw i t c h e s m a i n A C p o w e r o n o r o f f . Illuminates when the unit is ON. You can extend the life of the amplifier