Page 1
Hygienic Solutions at Work
Ready to Ship Stock Series Grab Bars, Stainless Steel
Code 1001NP 18":
Code 1001NP 24":
Code 1001NP 30":
Code 1001NP 36”:
Code 1001NP 48":
Peened
18”, 24”, 30”, 36” & 48”
There are three recessed
locations on the flange
cover that snap onto the
backplate.
Backplate,
with full bead
Wall
weld to tube
1-1/2" dia. Stainless steel, peened finish
1-1/2" dia. Stainless steel, peened finish
1-1/2" dia. Stainless steel, peened finish
1-1/2" dia. Stainless steel, peened finish
1-1/2” dia. Stainless steel, peened finish
Wall
1/2"
(1.3)
3” (7.6)
Side view
showing flange loose
while mounting
Concealed mounting screws, using snap flange, on ”SP & NP” codes
Section through
centre of flange
Mounted view
Specifications:
The Frost NP series stock grab bars are of an all stainless steel construction.
The brushed and peened finish make this an attractive, cost effective product to specify for any
Installation.
Stamped flange is 12 gauge stainless steel with a full 360 degree bead weld to the 18 gauge
stainless steel tubing.
Features concealed mounting detailing as shown in the illustration above.
Barrier Free Access:
The Frost NP grab bar series comply with handicap codes requiring 1-1/2” bar diameter and
wall clearance of 1-1/2".
Barrier free access specifications may vary depending on jurisdiction.
Safety Warning: All grab bars must be installed by qualified trades persons. Installers must
consult and comply with local building codes. Mounting hardware and other systems to be
determined by contractor and installer pending specific structure, design, and conditions. All
installations must be fully inspected and approved by property owners and maintenance
personnel prior to product being put into use. Failure to comply to proper installation procedure
will void warranty and may result in malfunctioning or injury.
Description and specifications applicable on date issued. Frost reserves the right to make improvements or changes without notice.
Loading...