Frontgate Amina Gas Table Base Owner's Manual

Amina Gas Table Base - Bronze

Item# 160188B AMB
Model# HYFP50095-113

DANGER

If you smell gas:

1. Shut off gas to the appliance.

3. If odor continues, keep away from
the appliance and immediately call

e department.

WARNING

Do not store or use gasoline or other

vicinity of this or any other appliance.
An LP-cylinder not connected for use
shall not be stored in the vicinity of
this or any other appliance.

WARNING

For outdoor use only.

WARNING
Improper installation, adjustment, alteration, service or maintenance can cause injury or
property damage. Read the owner’s manual thoroughly before installing or servicing this

result causing property damage, personal injury or loss of life.

Save these instructions for futur
assembling this unit for someone else, give this
manual to him or her to r

e.

futur

e use. If you ar

ead and save for the

e

Owner’s Manual

SAFETY INFORMATION

Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so
may r

WARNING

The installation of this unit must adhere to local codes or either the National Fuel Gas Code, ANSI

Z223. 1/NFPA54, OR CAN/CGA-B149.1, National Gas and Propane Installation Code.

THIS UNIT IS INTENDED FOR OUTDOOR USE ONLY! This product shall be used outdoors, in a

ventilated space and shall not be used in any enclosed area.

This unit is to be used with propane gas only! (sold separately)
Do not attach a remote gas supply to this unit.
Only use propane gas for this unit.

Do not use any solid fuel or charcoal for this unit.

LP GAS WARNING: Do not use any more than 1/4in depth lava rocks/pumice stones/LavaGlass®

above the bur

If the propane gas tank is leaking gas, you may hear, see, or smell a hiss. Do the following:

e department for help.

Applying too much propane may result in gas pooling and will not burn. Allow fresh air into the unit

so that the remaining gas may escape.

The max. inlet supply pressure: max. Gas supply 11 in w.c. (2.74kPa)

Use LP propane tanks with the following dimensions: diameter 12 in, height 18 in - capacity 20 lbs.

You must use a propane tank that has a collar to protect the gas valve.

The tank system must be set up for vapor withdrawal.
Discontinue use if any part of the propane tank is damaged. Rust and dents may be hazardous and

should be inspected by a gas supplier.

rocks/pumice stones/LavaGlass®could pop out and cause injury. Should any rocks pop out, discard
them.

Always ensure that lava rocks/pumice stones/LavaGlass® are completely dry before use. Failure to

do so will cause them to crack or pop.

Do not operate unit until all parts are fully assembled.
Do not paint or color any part of this heating unit.
Unit may be hot while in use, do not attempt to move it while in use.
Never leave this heating unit unattended while in use.
This unit is not intended for cooking.

Keep a safe distance to avoid burning skin or clothing.
Do not sit or rest hands or feet on this heating unit.

Keep all electrical cords and fuel supply hose away from heated surfaces.

Page 2

• Combustible material should not be within 72 inches of the top of the unit, or within 48 inches
around the entire unit.

vapors and liquids.

• Do not add water into the unit.

• Do not operate unit if any part has been under water. Immediately call a

technician to inspect the appliance and replace any part of the control system and any gas
control that has been under water.

• Do not disconnect any part while unit is in use.

• Do not store a spare propane tank on or near this unit.

• If the heating unit is indoors, detach the propane tank and leave it outdoors.

• Always remove protective cover before operating (if applicable).

• Do not set a protective cover over the unit until it is turned off and completely cooled down.

• Check for leaks after not using the unit for long periods of time.

• Children should never operate this unit. Children must be supervised while near this unit.

• Keep gas tank at least 5 feet away from unit when lit. (if external tank)

• The maximum gas supply pressure is 250psi.

inspected annually and cleaned regularly.

• Inspect all elements of this heating unit before each use. If there is damage, the burner must be
replaced.

• Keep the hose out from any pathways to eliminate any accidental damage. (if external tank)

• Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or

injury.

of the U.S. Department of Transportation or the National Standard of Canada CAN/CSA-B339, LP gas
tanks, spheres and tubes for Transportation of Dangerous Goods; and Commission.

gas tank connection.

ks.

• Children and adults should be alerted to the hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.

• Young children should be carefully supervised when they are in the area of the appliance.

near the appliance.

• Any guard or other protective device removed for servicing the appliance shall be replaced
prior to operating the appliance.

may be required as necessary. It is imperative that the control compartment, burners and
circulating airways of the appliance are kept clean.

IF APPLICABLE:

• Allow heating item to cool completely before placing on lid.

• DO NOT use heating item while lid is installed. Always remove the lid while heating item is in use.

Page 3

SAFETY INFORMATION

Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied
directly by Bond Manufacturing Co., Inc.

Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate
the appliance.

NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
valve is turned “OFF” before assembling. Do NOT attempt to assemble without proper tools.

Min. Clearance

48 in (121.9 cm)

Min. Clearance

48 in (121.9 cm)

Min. Clearance

48 in (121.9 cm)

Combustible materials should not be within 72
inches of the top of the unit, or within 48 inches
around the entire unit.

Min. Clearance

48 in (121.9 cm)

HARDWARE

AA BB CC

AA Flat Washer 3
BB Lock Washer 3
CC Screw M8*20 3

ytQnoitpircseDmetI

Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any parts are missing or damaged, do not
attempt to assemble the product.

Estimated Assembly Time: 20 minutes
Tools Required for Assembly (not included): Phillips Screwdriver

Page 4