Front Electronics PS6PMCM User Manual
Modem Charging Cradle
User Guide
This user guide provides an overview of setting up and
using your new Modem Charging Cradle.
Model Number: PS6PMCM
Box Contents
Please check the Modem Charging Cradle carton for the
following required items:
• Modem Charging Cradle
• Power Adapter
• Quick install card
• Warranty card
For more information about these items see More about the
Box Contents on page 4.
Copyright© 2006 Mobility Electronics, Inc. All rights reserved.
The information in this document is subject to change without notice.
Disclaimer
Mobility Electronics, Inc. assumes no responsibility for any damage or
loss resulting from the use of this user guide. Mobility Electronics, Inc.
assumes no responsibility for any loss or claims by third parties that may
arise through the use of this product. Mobility Electronics, Inc. assumes
no responsibility for any damage or loss caused by deletion of data as a
result of malfunction, dead battery, or repairs. Be sure to make backup
copies of all important data on other media to protect against data loss.
First Edition, Updated — March 2006 Rev: A1
Palm OS is a registered trademark of PalmSource, Inc.,
Palm is a trademark of Palm, Inc. or its subsidiaries.
Third-party products and brand names may be trademarks or registered
trademarks of their respective owners.
All other registered trademarks, trademarks, service marks, and/or logos
are the property of their respective companies.
User’s Guide for Modem Charging Cradle PS6PMCM 2
Table of Contents
Introduction ............................................................................................4
About the Modem Charging Cradle ....................................................4
Minimum Requirements......................................................................4
Product Registration...........................................................................4
More about the Box Contents.............................................................4
Chapter 1 – Preparing to Use the Modem Charging Cradle ................6
Installation Overview ..........................................................................6
Preparing the Modem Charging Cradle for First Use..........................6
Configuring the Network Manager for Modem Communication...........7
Chapter 2 – Product/Technical Support ...............................................8
Product Support .................................................................................8
Technical Support ..............................................................................8
Appendix A – Regulatory Information ..................................................9
Telecom Compliance, Warnings, and Notices ..................................10
Appendix B – Warranty........................................................................12
Glossary................................................................................................13
User’s Guide for Modem Charging Cradle PS6PMCM 3
Introduction
About the Modem Charging Cradle
The Modem Charging Cradle enables a telephone connection to a host
computer. Palm Tungsten E2 handheld users can access and transfer
critical information as easily as making a phone call. The cradle
communicates via serial transmission with the Palm handheld. Before it
can transfer data over the telephone line, the cradle will require third party
software to be installed on the handheld.
NOTE
Palm does not support HotSync over a serial connection, thus
HotSync is not a supported application for this device.
Minimum Requirements
The following minimum requirements must be met for the network,
handheld and desktop computer to work together:
• Palm Tungsten E2 or compatible handheld
• Power Adapter
• Modem Charging Cradle
• RJ11 phone cable
• A desktop computer connected to a V.34 (or later) modem.
Product Registration
Thank you for purchasing this iGo product. We strongly encourage you to
register this product so that we may keep you notified of pertinent
updates and relevant product information. Failure to register does not
diminish your warranty rights. We provide free product support to
registered users for the first 90 (ninety) days from the purchase date.
Registration may be completed online at: www.igo.com/registration.
More about the Box Contents
Modem Charging Cradle
The Modem Charging Cradle is designed for and communicates serially
with the Palm Tungsten E2 or compatible handheld.
The cradle’s custom-designed mechanical interface connects to the
handheld in the front, and connects to required services using its three
rear connections:
• A power receptacle for its power adapter.
• A Line In phone jack that connects the wall (or telephone
company) line into the device.
• A Line Out phone jack that passes the signal through the device
to a phone or other device that shares the line.
User’s Guide for Modem Charging Cradle PS6PMCM 4
Loading...