TransPuls Synergic
TransSynergic Comfort
1
Setting the wire diameter
Special diameter
2
Specifying the filler metal and
shielding gas
Special setting
6
Correcting parameters
- select desired parameter
- correct desired parameter
Arc length correction
Arc-force dynamic correction / pulse correction / arc-force dynamic
Arc voltage
Quick Reference: English
5
Setting the welding power
- select desired parameter
- set desired parameter
Specify sheet thickness
Specify welding current
Specify wire feed speed
Important! In synergic mode, all the remaining
parameters are set automatically.
Note! If external system components are connected, some parameters can be modified on those
components. The power source control panel is
only for display purposes.
3
Setting the mode
2-step mode
4-step mode
Special 4-step mode
(Aluminium welding start-up)
Spot welding
Special function
42,0426,0038,EN 01/2022
-
1 6
Text and illustrations were accurate at the time of printing. We reserve the right to make amendments.
Commissioning sequence
Follow operating instructions
Feeder inching
Gas test
Setup/store
Fronius International GmbH, www.fronius.com
4
Selecting the process
MIG/MAG pulse synergic
MIG/MAG standard synergic
MIG/MAG standard manual
Job mode
TIG
Rod electrode (MMA)
TransPuls Synergic
TransSynergic Comfort
MIG/MAG - setup
2-step mode
Starting current
Slope
final current
time - starting current
time - end current
MIG/MAG - setup
Special 4-step mode
Starting current
Slope
final current
MIG/MAG - setup
Spot welding
MIG/MAG - setup WIG - setup
Procedure
or
Gas pre-flow time
Gas post-flow time
Wire feeder creep
Feeder inching speed
Burn back correction
Hotstart current *
Hotstart time *
Frequency **
Wirefeed deviation **
Arc length correction
Return to factory setting
2nd menu level
Select push-pull unit
Cooling unit control
Cooling unit watchdog
Ignition timeout
Arc-break watchdog
Wire-end settings
Country setting
Special 2-step variants
Special 4-step variants
JobMaster mode select.
Welding cct resistance
Welding cct inductivity
Gas correction ***
Gas - setup
2nd menu level
Cooling unit control
Cooling unit watchdog
Comfort stop sensitivity
Welding cct resistance
Welding cct inductivity
Gas pre-flow time
Gas post-flow time
Gas flushing
Gas flow rate ***
Job correction
For details of Job mode
and Job correction, see
operating instructions
Quick Reference: English
Electrode - setup
Hotstart current
Hotstart time
2nd menu level
Welding cct resistance
Welding cct inductivity
Charactaristic selection
Anti-stick
Break voltage
Exit setup
Exit setup
Save job
Spot-welding time
* only for standard synergic process
** only with SynchroPuls option
*** only with digital gas control option
Display firmware versions
Power source firmware
Wirefeeder firmware
Welding database
Total welding time
e.g.
e.g.
e.g.
e.g.
Loading...