TransTig 170, TransTig 210
Control Panel Overview | Setting Welding Parameters
SAFETY
Before working with the device, ensure that you have read and understood all the documents provided in hard copy and online.
This document does not describe all the functions of the device. For a complete description of the device, refer to the Operating
Instructions.
Control Panel Overview
Setting the welding parameters
1. Press selection dial to enable
parameter selection
42,0426,0327,EA 004-01082022
To select the operating mode
2-step mode: Short weld seams
4-step mode: Longer weld seams
SMAW
Allow shielding gas to flow out for 30
seconds
2. Turn selection dial to select
the desired parameter
3. Press selection dial to confirm
the selected parameter
Adjustable welding parameters
Starting current
Up-Slope
Main current (welding current)
Reduced current
Down-Slope
Final current
Pulses
Tacking
4. Turn selection dial to select
the desired value
TransTig 170, TransTig 210
Description of Setup Parameters
Accessing the Setup menu
2. 1.
1. Press and hold
2. Press
Exiting the Setup menu
Rod electrode Setup menu
HotStart current
Starting current duration
Start ramp
Pulse frequency
Anti-stick
CEL mode
Dynamic correction
Break voltage
Reset welding system
Setup Menu 2nd Level
TIG Setup Menu, 1st Level
Electrode diameter
Spot welding time/interval welding
time
Interval pause time
Tacking
Pulse frequency
Duty cycle
Base current
Starting current time
Final current time
Gas pre-flow time
Gas post-flow time
Gas purging
Reset welding system
TIG Setup Menu, 2nd Level
Setup Menu 2nd Level
Setup Menu 2nd Level (TIG and SMAW)
System active-time
System on-time
Fuse
Software version
Automatic shutdown
TIG Setup Menu, 2nd Level
Welding circuit resistance
Slope time 1
Slope time 2
Trigger mode
HF ignition
Pulse TAC Display
Ignition time out
Arc break monitoring
Comfort Stop sensitivity
Break voltage
Main current changeover
Operating Instructions
i
https://manuals.fronius.
com/html/4204260308
Loading...