last rev: 04.11.2010
I - IDENTIFICATION AND GENERAL DATA
Product details:
Trade name:
Robacta TC Cool
Part-number:
42,0411,8038
42,0411,8039
42,0411,8043
42,0411,8044
Manufacturer/Supplier:
Fronius International GmbH
Fronius Straße 5
A-4642 Sattledt
Tel.: +43 / (0)7242 / 241-0
Fax: +43 / (0)7242 / 241-8799
Emergency hotline:
Austrian Anti-Poison Center +43 / (0)1 / 4064343
Page: 1/3
MATERIAL SAFETY DATA SHEET
Office to contact for information:
TSI (TechSupport International)
Tel.: +43 / (0)7242 / 241-3440
Fax: +43 / (0)7242 / 241-3930
e-mail: welding.techsupport@fronius.com
www.fronius.com
II – PRODUCT AND COMPONENT DATA
Components: % CAS NO. ACGIH TLV
Dihydrogen Oxide >80% 007732-18-5 none known
Polyethylen glycol <20% 25322-68-3 none known
Be-2 Coating Blue trace 2861-02-1 none known
III - PHYSICAL/CHEMICAL CHARACTERISTICS
Appearance and color: liquid, blue, no appreciable odor
Boiling point: 212°F
Vapor pressure: 17.5mm Hg @ 20°C (water)
Vapor density in air: 17.3 GM-3 (water)
Evaporation rate: 1 mg/1 (water)
Melting point: not applicable
Specific gravity: 1.0
Solubility: 100% in water @ 25°C
% Volatile by volume: not applicable
% Solid: not applicable
Ph value at 20°C: 7,7
VI – FIRE AND EXPLOSION HAZARD DATA
Flash point: not applicable
Flammable limits in air: not applicable
Extinguishing agents: water, foam, dry chemical, carbon dioxid (CO2)
Unusual fire and explosion hazards: none known
0
01
V – REACTIVITY DATA
Robacta TC Cool
Page: 2/3
Stability: stable
Incompatibility: oxidizers, alkalies, acids
Hazardous decomposition products none
Hazardous polymerization: will no occur
Conditions to avoid: none
VI – HEALTH HAZARD DATA AND FIRST AID
Medical conditions aggravated by exposure: none known
Acute toxiticy: none known
Inhalation: none known
Skin: none known
Eyes: eye irritant
Ingestion: may cause nausea
Chronic toxicity: none known
FIRST AID:
Inhalation: not applicable
Skin: flush with large quantities of water
Eye: flush eyes immediately with water
Ingestion: give large quantities of water
NOTE TO PHYSICAN: none
Material safety data sheet acc. 91/155/EG
VII – PERSONAL PROTECTION AND CONTROLS
Respiration protection: no special requirements
Ventilation: no special requirements
Skin protection: protective gloves, apron
Eye protection: wear safety glasses or splash googles
Other control measures: eyewash station should be available
VIII – SPILL, LEAK AND DISPOSAL PRACTICES
Steps to be taken in case material is released or spilled:
Absorb with an inert ingedient such as sand, earth or vermiculite and dispose of in accordance with
federal, state and local regulations.
Waste disposal method:
Consult with federal, state or local authorities for approved procedures.
Precautions to be taken in handling and storing:
Store in a cool dry area
Other precautions:
none
IX – TRANSPORTATION INFORMATION
International transportation regulation:
Preparation is not covered by international regulations on the transport of dangerous goods.
X – NFPA RATING
Robacta TC Cool
Loading...