/ Perfect Welding / Solar Energy / Perfect Charging
1
2
3
4
5
6
TransSteel 2200
Quick Guide to synergic welding
SAFETY
Before working with the device, ensure that you have read and understood all the documents provided in hard copy and online.
This document does not describe all the functions of the device. For a complete description of the device, refer to the Operating Instructions.
Set the synergic welding process
When setting a welding power parameter, the
remaining parameters are set automatically
MMA welding
TIG welding
The welding power parameters can be adju-
sted individually
Set the welding power
Sheet thickness
Welding current
Set the filler metal and shielding gas
2.1. 3.
Adjust the parameters for correction
Arc length correction
Welding voltage
Set the operating mode
2-step mode: short weld seams, tacking work
4-step mode: longer weld seams, high level of
comfort
Special 4-step mode: additional settings for star-
ting and nal current
Spot welding: for overlapping sheets / stitch
welding: light-gauge sheet welding and air-gap
bridging
Optimise welding results
1. Measure the welding circuit resistance r
2. Set the mains fuse so that the device switches o
before the mains fuse trips.
Wire speed
select desired parameter
set desired parameter
42,0426,0263,EN 004-09042019
select desired parameter
set desired parameter
Arc-force dynamic
The description of the aforementioned measures can be
found in the Operating Instructions of the power source
Operating Instructions:
1x
MIG/MAG Synergic Setup menu
MIG/MAG Manual Setup menu
MMA Setup menu
1. 2. 2.
Level 1 Setup menu
Gas pre-ow time
Gas post-ow time
Slope (2-step, special 4-step)
Starting current (2-step, special 4-step)
Final current (2-step, special 4-step)
Starting current duration (2-step)
Final current duration (2-step)
Feeder inching speed
Length of wire that is fed before the safety cut-out
trips
Spot welding time / interval welding time
Interval pause time
Operating mode for stitch welding
Restore factory setup
Level 2 Setup menu
Country-specic setting
Welding circuit resistance
Welding circuit inductivity
Real Energy Input
Mains fuse protection
Arc length correction display
EasyJobs
1. 2.
Level 1 Setup menu
Gas pre-ow time
Gas post-ow time
Feeder inching speed
Ignition current
Length of wire that is fed before the safety
cut-out trips
Spot welding time / interval welding time
Interval pause time
Operating mode for stitch welding
Restore factory setup
Level 2 Setup menu
Country-specic setting
Welding circuit resistance
Welding circuit inductivity
Real Energy Input
Mains fuse protection
Exiting the Setup menu
Activating/deactivating the key lock
2.
1. 2. 2.
Level 1 Setup menu
HotStart current
HotStart time
Anti-stick
Restore factory setup
Level 2 Setup menu
Country-specic setting
Welding circuit resistance
Welding circuit inductivity
Mains fuse protection
TIG Setup menu
2.2.1.
Level 1 Setup menu
Pulse frequency
UpSlope
DownSlope
Starting current
Reduced current
Final current
Gas post-ow time
Tacking
Restore factory setup
Level 2 Setup menu
Country-specic setting
Mains fuse protection
Retrieve:
Save:
Delete:
Available parameters: Example of display:
Firmware version
Welding program conguration
Current welding program
Display service parameters
Arc time in hours
Motor current for wire drive in ampere
2nd menu level (Service)
Loading...