
according to Regulation (EC) No. 1907/2006 (REACH)
Magic Cleaner Marking Electrolyte
42,0411,0167
SECTION 1: Identification of the substance/mixture and of the company/ undertaking
Magic Cleaner Marking Electrolyte
42,0411,0167
Relevant identified uses of the substance or mixture and uses advised against
Details of the supplier of the safe ty data sheet
Supplier (manufacturer/importer/only representative/downstream user/distributor)
Fronius International GmbH
Street : Fronius Straße 5
Postal code/city : A-4642 Sattledt
Telephone : +43 (0)7242 241-0
Telefax : +43 (0)7242 241-8799
Internet: www.fronius.com
Information contact : msds.techsupport@fronius.com, welding.techsupport@fronius.com
Emergency telephone number
+43 (1) 406 43 43 during normal office hours
SECTION 2: Hazards identification
Classification of the substance or mixture
Classification according to Regulation (EC) No 1272/2008 [CLP]
SECTION 3: Composition/information on ingredients
SECTION 4: First aid measures
Description of first aid measures
When in doubt or if symptoms are observed, get medical advice.
Remove casualty to fresh air and keep warm and at rest. In case of respiratory tract irritation, consult a physician.
After contact with skin, wash immediately with plenty of water and soap. In case of skin reactions, consult a physician.
After contact with the eyes, rinse with water with the eyelids open for a sufficient length of time, then consult an
ophthalmologist immediately.

according to Regulation (EC) No. 1907/2006 (REACH)
Magic Cleaner Marking Electrolyte
42,0411,0167
Most important symptoms and effects, both acute and delayed
No information available.
Indication of any immediate medical attention and special treatment needed
SECTION 5: Firefighting measures
Suitable extinguishing media
Carbon dioxide (CO2) Foam Extinguishing powder Water spray jet
Special hazards arising from the substance or mixture
Do not inhale explosion and combustion gases.
Cool down endangered containers with full water-jet. Use foam in high amounts. Contaminated tempering water is
gathered separately and may not reach the sewage system. Use suitable breathing apparatus.
The product itself does not burn. Co-ordinate fire-fighting measures to the fire surroundings.
SECTION 6: Accidental release measures
Personal precautions, protective equipment and emergency procedures
Special danger of slipping by leaking/spilling product. Use personal protection equipment.
See protective measures under point 7 and 8.
Environmental precautions
Do not allow to enter into soil/subsoil. Do not allow to enter into surface water or drains. Prevent spread over a wide
area (e.g. by containment or oil barriers).
Methods and material for containment and cleaning up
Absorb with liquid-binding material (e.g. sand, diatomaceous earth, acid- or universal binding agents ). Clear spil ls
immediately. Treat the recovered material as prescribed in the section on waste disposal.
Reference to other sections
Safe handling: see section 7
Disposal: see section 13
SECTION 7: Handling and storage
Precautions for safe handling
Keep container tightly closed.
Conditions for safe storage, including any incompatibilities
Keep/Store only in original container. Protect against Frost
Observe technical data sheet. Observe instructions for use.
SECTION 8: Exposure controls/personal protection
Personal protection equipment
Personal protection equipment: see section 8

according to Regulation (EC) No. 1907/2006 (REACH)
Magic Cleaner Marking Electrolyte
42,0411,0167
Wear suitable safety goggles in case of splash.
Wear protective gloves in case of longer lasting skin contact.
Suitable gloves type : EN 374.
Suitable material : NBR (Nitrile rubber)
Breakthrough time (maximum wearing time) : 480 min.
Thickness of the glove material : 0.4 mm
Remark : The exact break trough time has to be requested from the protective glove manufacturer and limits has to
be ensured.
Do not put any product-impregnated cleaning rags into your trouser pockets. When using do not eat, drink, smoke,
sniff. Avoid contact with skin, eyes and clothes. Remove contaminated, saturated clothing immediately.
No tests have been performed. Selection made for preparations according to the best available knowledge and
information on ingredients. In the case of preparations the resistance of glove materials cannot be calculated in advance
so it has to be tested before use.
SECTION 9: Physical and chemical properties
Information on basic physical and chemic al properties
Initial boiling point and boiling range
:
Solvent separation test :
Maximum VOC content (EC) :
Maximum VOC content (Switzerland)
:
( 1013 hPa )
0
100
°C
Wt %