Certificate of Compliance
Certificate:
Project:
Issued to: Fronius International GmbH
2371974
2542544
Guenter Fronius Strasse 1
Wels-Thalheim, 4600
Austria
Attention: Mr. Josef Feichtinger
The products listed below are eligible to bear the CSA
Mark shown with adjacent indicators 'C' and 'US' for
Canada and US or with adjacent indicator 'US' for
US only or without either indicator for Canada only.
Issued by:
Master Contract:
Date Issued:
Ramana Tangirala
Ramana Tangirala, P.Eng.
203213
July 10, 2012
PRODUCTS
CLASS 5611 81
CLASS 5611 01
Welding Equipment Accessories:
PART A:
Model FCU 20 (Fronius Control Unit) may be followed with suffixes, control unit exclusively for Fronius turn
tables (FTT), Fronius Rotation Table (FRT) and Fronius Rotilting Positioner (FRP) rated as follows:
Input: 230 V ac, 1 A, 50/60 Hz; Output: 24 VDC, 0.4 ADC, IP23, Cord and Plug Connected.
PART B:
Model “460/230 Transformerbox”, Step-down isolation transformer, converts the voltage from 460 V ac,
50/60Hz, 2500VA to 230 V ac, 50/60 Hz, permanently connected.
- WELDING MACHINES - Certified to US Standards
- WELDING MACHINES
DQD 507 Rev. 2012-05-22 Page: 1
Certificate:
2371974
Master Contract:
203213
Project:
2542544
Date Issued:
July 10, 2012
PART C:
Model FRP150/HS125, Rotating Positioner (or rotating and tilting unit) for welding work pieces. Rated as
follows:
Input: 230V ac, 1 ph, 50/60 Hz, 0.8A max load, 0.18kVA;
Notes:
1) Certified for use only with certified Fronius welding power sources where power ratings are less than or
equal to ratings.
2) Installation of equipment not provided with power cord and plug is subject to the approval of the local
inspection authority.
APPLICABLE REQUIREMENTS
CSA Std C22.2 No. 60 - Arc Welding Equipment
*CSA Std C222.2 No. 14 - Industrial control Equipment
* CSA Std C22.2 No. 66.1 - Low voltage Transformers Part 1 – General requirements
* CSA Std C22.2 No. 66.2 - Low voltage Transformers Part 2 – General purpose transformers
*CAN/CSA –E60974-1 - Arc Welding Equipment, Part 1: Welding Power Sources
UL Std No. 551 - Transformer-Type Arc-Welding Machines
* UL508 - Industrial control Equipment
* UL 5085-1 - Low voltage Transformers Part 1 – General requirements
* UL 5085 - Low voltage Transformers Part 2 – General purpose transformers
*UL 60974-1 - Arc Welding Equipment, Part 1: Welding Power Sources
* used as a guide
DQD 507 Rev. 2012-05-22 Page: 2
Loading...