ADDING A PV SYSTEM TO FRONIUS
SOLAR.WEB
Instruction of how to add a system into Solar.web account
Quick Guide
© Fronius Australia Pty Ltd., SF
Version 2.0/2020
Fronius reserves all rights, in particular rights of reproduction, distribution and translation.
No part of this work may be reproduced in any way without the written consent of Fronius. It must not be saved, edited,
reproduced or distributed using any electrical or electronic system.
You are hereby reminded that the information published in this document, despite exercising the greatest of care in its
preparation, is subject to change and that neither the author nor Fronius can accept any legal liability
Gender-specific wording refers equally to female and male form.
(c) Fronius Australia Pty. Ltd, 01/2020 1/3
1
2
youremail@test.com
1. Go to www.solarweb.com
2. Login to your Solar.web account
Note that: if you do not have an account, you are required to create an account.
Please see the attached quick guide ‘Fronius Solar.web Account Registration’
3. Click ‘+ Add PV system’
Or if you have other existing systems, please go to the top right of the page and click on
Then you can see the option ‘+ Add PV system’ option
(c) Fronius Australia Pty. Ltd, 01/2020 2/3
For normal grid connected Fronius inverters
240.XXXXX
Fronius Symo Hybrid inverters
239.XXXXX
5
4. Give your PV System a name
5. Click ‘ADD’ under Devices &
Select Datamanager
6. Put in you Datalogger ID*
Do not know your Datalogger ID?
Please see information at the end
of this document
7. Click on ‘I’m not a robot’
and verify
8. Click ‘SAVE’ on the top of this page
240.xxxxxxx
To find your Datalogger ID:
1. On the inverter, go to ‘Setup’ menu, press enter
2. Go to ‘Wi-Fi Access point’ then activate the Wi-Fi AP
3. On your smart phone/ tablet/ laptop, go you Wi-Fi setting
4. You will see Fronius network name ‘Fronius_240.xxxxxxx’, the 240.xxxxxxx is your Datalogger ID
(For Hybrid inverter, the number will be ‘Fronius_239.xxxxxx’)
1. Access your Fronius inverter’s Menu by pressing the 2nd button from the left
2. Press the 4th button from the left to enter Setup
3. Select Wi-Fi Access Point
4. Your Fronius Datalogger ID will be in one of the following formats:
(c) Fronius Australia Pty. Ltd, 01/2020 3/3
Loading...