Page 1
Getting started
with your
multi-door
refrigerator
Before you start
Set up your refrigerator
Remove tape and glue residue from surfaces before turning on the refrigerator. Choose a place near a grounded electrical
outlet, allowing for clearances for ease of installation, proper circulation, and plumbing and electrical connections.
Before operating for the first time
After you remove all of the package materials, clean the inside of your refrigerator before using it.
See CARE AND CLEANING in your Use & Care Manual.
You’re in control
Your appliance control display*
We recommend you set your temperatures at 37˚F (3°C) for the refrigerator compartment and 0˚F (-18°C) for the freezer. After
24 hours, you can adjust the control as desired, allowing the temperature to stabilize.
*Control display varies by model. See the Use & Care Manual for more detailed information about your appliance.
EXTERNAL DISPENSER CONTROL DISPLAY SIDE DOOR DISPENSER CONTROL DISPLAY
1
2
3
4
Activate Freeze Boost prior to grocery shopping to lower the
1
temperature and freeze food faster. Freeze Boost remains active
for up to 24 hours.
2
Press Cold Drink Timer to start a timer for chilling drinks.
The ice maker makes ice until the ice bin is full. Press and hold
3
Ice Maker for 3 seconds to turn it on/o.
Press and hold for 3 seconds to enable/disable the appliance
4
control display.
Press either + or — to adjust to desired temperature setting
5
inside the refrigerator or freezer compartment. Adjusting Temp
illuminates until you reach the desired temperature(s).
Power Outage illuminates and alert sounds after a power outage
6
ends until you reset it by pressing any button.
Door Open illuminates and alert sounds if the door is open 5+
7
minutes until you close the door.
°F/°C allows you to switch between Fahrenheit (°F)
8
and Celsius (°C).
Replace Water Filter or Replace Air Filters illuminates when it’s
9
time to change the filters, generally every 6 months.
Prior to grocery shopping, we recommend you activate Chill
10
Boost to cool your food faster.
5
9 9
6
7
8
Use to lock the display. Press and hold
1
10
1
2
3
4
6
8
5
7
for 3 seconds to enable/disable. The
indicator flashes and an alert sounds
when CONTROL LOCK is enabled. You
can’t make changes on the display while
the lock is engaged.
Select compartment for temperature
2
change (FREEZER or REFRIGERATOR).
Press either the + or — to adjust to
desired temperature setting.
Freezer temp - Control temperatures
range from -6°F / -21°C to +6°F / -15°C.
Refrigerator temp - Control
temperatures range from +34°F / +1°C
to +44°F / +7°C. This unit is designed
to operate at 37°F Refrigerator/0°F
Freezer. Temperatures should stabilize
within 24 hours of installation.
Clear Alerts resets any alarms that are
3
active and illuminated on the display
(Door Open, High Temp,
Power Outage).
Activate Freeze Boost prior to grocery
4
shopping to lower the temperature and
freeze food faster. Freeze Boost remains
active for up to 24 hours.
°F/°C allows you to switch between
5
Fahrenheit (°F) and Celsius (°C).
Press and hold for 3 seconds to
6
enable/disable the water dispenser.
When enabled, the LEDs above Water
Dispenser illuminates.
Press and hold Default Settings for 3
7
seconds to reset to default settings.
Press and hold Water Filter or Air
8
Filters for 3 seconds to reset after
replacing the filter.
A23751103 (2209)
Page 2
Keep it fresh
Frigidaire PureAir®® AF-2™ Replacement Refrigerator Air Filter (1 included)
• More powerful than baking soda, the new PureAir AF-2 Replacement Refrigerator Air Filter absorbs
• The air filter is located at the top center of the refrigerator compartment. To change your filter:
Frigidaire PurePour Connect™™ PWF-2™ Ice & Water Refrigerator Filter (1 installed)
• Makes safer water second nature - certified to reduce contaminants and keep great-tasting water flowing
• The water filter is located at the top right side of the refrigerator compartment.
• Before dispensing water for the first time, be sure to prime the water supply system (NOTE: Ensure you
=
Install your new PureAir PK-2 Produce Keeper Plus™ Refill to extend the life of
produce (2 included)
For optimal results, replace your air and water filters every 6 months, and your Produce Keeper Plus every 12 months.
undesirable smells keeping your fridge fresher for up to 6 months.
1. Remove the air filter cover by squeezing the top and bottom of the cover together and removing it from
the liner.
2. Remove the old filter and discard it.
3. Unpack the new filter and snap it into the filter cover. Install the open face (carbon media) of the filter
facing outward in the cover.
4. Replace the air filter cover by squeezing the sides and snapping it back into place.
5. To reset, after replacing the filter, press and hold Air Filter on the appliance control display for 3
seconds. The status will reset to GOOD.
for you and your family for up to 6 months.
enable Water Dispenser on SIDE DOOR DISPENSER models. LEDs above the button are lit.) :
1. Hold a glass against the paddle for about 4 minutes to purge air from the system.
2. Continue dispensing at least 1 full gallon (3.6 L) of water and discard.
1. Remove the outer plastic wrapper.
2. Insert the unopened packets into the holder in the Crisper, as shown on the left.
FRGPAAF2™
FPPWFU02™
FRPAPK2RF™
FAQs
My refrigerator is making unfamiliar sounds. Is this normal?
Your new, high-eciency unit may introduce unfamiliar sounds. These sounds normally indicate your appliance is
operating correctly. See the NORMAL OPERATING SOUNDS section of your Use and Care Manual for more information.
How do I use the side door dispenser?
Your side door dispenser is located in the left hand refrigerator door. To use the dispenser simply hold the door with
one hand while placing your glass under the nozzle and pushing the paddle to dispense water with your other hand. If
your glass doesn’t enable the paddle due to size, use your finger to activate the paddle for dispensing.
Why does my refrigerator seem to run continuously?
Your variable speed compressor is designed to run 100% of the time except during the defrost cycle. At times it will
run faster, such as after a defrost cycle.
How does my CrispSeal® Fresh Crisper work?
Our crispers block out dry air and slow down the aging process of your produce by reducing ethylene gases, which
cause produce to ripen faster.
Good news – no settings needed! CrispSeal Fresh crispers are equipped with an automatic humidity control
membrane. We do not recommend replacing the auto-humidity membrane unless it becomes damaged or dirty.
If the membrane requires cleaning, you can simply wash it with soap and water. Make sure you thoroughly dry the
membrane before replacing in your refrigerator.
For more information refer to TROUBLESHOOTING in the back of your Use & Care Manual.
Let’s make it ocial!
Take the first step to becoming a part of the Frigidaire family and discover more benefits by registering your
multi-door refrigerator.
Look for the PhotoregisterSM icon on your registration card or register via the Frigidaire App.
SM
PHOTOREGISTER
We are
here
for you
Have a question?
Want help?
Need service?
Scan the QR Code to the right or visit
frigidaire.com • frigidaire.ca
for owner support
Loading...