Frigidaire LRA18HMU219, LRA18HMU218, LRA11PZW115, LRA11PZW114, LRA08PZU116 Owner’s Manual

...

IGIDAi

TABLE OF CONTENTS

Important Safety Instructions .......................... 2-3 Operating Instructions ........................................ 5-10

Product Registration .......................................... 4 Care and Cleaning .......................................... 11

Packaging ......................................................... 4 Energy Saving Ideas ..................................... 11

Normal Sounds .................................................. 4 Before You Call .................................................. !2

Atr Conditioner Features ...................................... 5 Major Apphance Limited Warranty ...................... 13

www frigidaire com USA 1-888-775-6937 www frigidaire ca Canada 1-800-668-4606

This USE & CARE MANUAL provides specific operating instructions for your model Use the room air conditioner only as instructed in this USE & CARE MANUAL These instructions are not meant to cover every possible condition and situation that

may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance

The power supply cord with this air conditioner contains a current

detection device designed to reduce the risk of fire•

Please refer to the section 'Operation of Current Device' for details•

In the event that the power supply cord is damaged, it cannot be repaired• It must be

replaced with a cord from the product manufacturen

........................................................................ follow basic precautions, including the following:

Avoid fire hazard or electric shock• Do not

Jse an extension cord or an adaptor plug. Do

_ _ installation instructions for possible future use in removing or reinstalling this unit.

II++_\ _GroundngProng ++ + The complete etectricat rating of your new room air conditioner is stated on the serial plate.

_ %_I Refertotheratingwhencheck+ngtheeiectr+ca_requ+..... ts.

lit 23ov I Do not, under any • Be sure the air conditioner is properly grounded• To minimize shock and fire hazards,

/'i o 3OA j circumstances cut proper grounding is important. The p ....... d is equipped with a three-prong grounding

\\\ II I I _+_ovorb '_++&e++ plugforprotectionagainstshocki_azards.

\\\ _j/ re e yp ;i ++*Yourarcondtionermustbeused naproperygroundedwa receptace Ifthewa

L% _7_ ground ng prong • •

Remark The a earance of actual lu ma or c rcu t breaker have a qua fled e ectr c an nsta the proper receptac e

be slightly different from the line drawing .... • Do not run air conditioner without outside protective cover in place• This could result in

shown in the figure. The line drawings are for mechanical damage within the air conditioner• reference only. + DO not use an extension cord or an adapter plug.

PP P g Y

+i+i

DO not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance• Read product labels for flammability and other warnings•

For Your Safety

Prevent Accidents

+oreducether+skoffire,olectr+ca+shock,or+njurytop....... h.... +ngy.... +.... d+tioner,

+ Be sure the electrical service is adequate for the model you have chosen• This information

can be found on the serial plate, which is located on the side of the cabinet and behind the grille•

+ If the air conditioner is to be installed in a window, you will probably want to clean both

sides of the glass first• If the window is a triple-track type with a screen panel included, remove the screen completely before installation• Be sure the air conditioner has been securely and correctly installed according to the

+ When handling the air conditioner, be careful to avoid cuts from sharp metal fins on front

and rear coils•

• receptacle you _ntend to use is not adequately grounded or protected by a time delay fuse

Do not insert or place fingers or objects into the air discharge area in the front of the unit. Do not start or stop the air conditioner by unplugging the power cord or turning off the power at the electrical box.

Do not cut or damage the power cord. If the power cord is damaged, it should only be replaced by an authorized Electrotux servicer•

In the event of a malfunction (sparks, burning smell, etc.), immediately stop the operation, disconnect the power cord, and call an authorized Electrotux servicer.

• Do not operate the air conditioner with wet hands•

• Do not pull on the power cord.

• Do not drink any water that is drained from the air conditioner.

CAUTION! Avoid Injury or damage to the unit or other property

• Provide occasional ventilation during use. Do not direct affflow at fireplaces or other heat related sources as this could cause flare ups or make units run excessively.

• Do not climb on or place objects on outdoor part of the unit.

, Do not hang objects off the unit.

• Do not place containers with liquids on the unit.

• Turn off the air conditioner at the power source when it will not be used for an extended period of time.

• Periodically check the condition of the unit's installation accessories for any damage.

• Do not apply heavy pressure to the radiator fins of the unit.

• Operate the unit with air filter in place.

• Do not block or cover the intake grille, discharge area and outlet ports. Ensure that any electrical/electronic equipment is one yard away from the unit.

, Do not use or store flammable gases near the unit.

READTHIS SECTION BEFOREATTEHPTING TO OPERATEAIR CONDITIONER. Unit must be upright for one hour prior to operating.

Operation of Current Device

Plug in & The power supply cord contains a current device that senses damage to the power cord. To test

press RESET

Remark: The appearance of actua_ plug may be slightly different from the _ine drawing shown in

the figure. The _ine drawing is for reference only.

your power supply cord do the following:

1. P}ug in the Air Conditioner. 2, The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will

notice a click as the RESET button pops out.

3. Press the RESET button. Again you will notice a click as the button engages. 4, The power supply cord is now supplying elec_tricity to the unit. (On some products this is also indi-

cated by a light on the ptug head).

, Do not use this device to turn the unit on or off. ' Always make sure the RESET button is pushed in for con-ect operation.

The power supply cord must be replaced if it fails to reset when either the TEST button is pushed, or it cannot be reset. A new one can be obtained from the product manufacturer. If power supply cord is damaged, it CANNOT be repaired. It MUST be replaced by one obtained

from the product manufacturer.

Product Registration Record Your Hodel and Serial Numbers

Record in the space provided below the model and serial numbers. On all models, the

serial plate is located on the outside of the cabinet,

Model No

Serial No

The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company.

Packaging Remove all packaging from inside the carton, along with any

inserts placed into the side louvers, Remove the plastic ties and foam pad that secure the

compressor to the fan shroud (where applicable). See diagram.

foam pad + plastic ties Packing Inserts

Normal Sounds

Sound of Rushing Air At the front of the unit, you may

hear the sound of rushing air being moved by the fan.

Gurgle/Hiss

"Gurgling or hissing" noise may be heard due to refrigerant passing

through evaporator during normal operation.

High pitched Chatter

Today's high efficiency compressors may have a high pitched chatter

during the cooling cycle.

Vibration

Unit may vibrate and make noise because of poor wall or window construction or incorrect installation.

Pinging or Swishing

- Droplets of water hitting condenser during normal operation may cause "pinging or swishing" sounds. Note: Don't try to drill any holes on the base pan to eliminate the

normal sounds, otherwise it will void the warranty.

+ 9 hidden pages