Frigidaire LFID2422RF4B, LFID2422RF3B, LFID2422RF2A, LFID2422RF0A, LFID2422RF1A Owner’s Manual

...
FRIGIDAIR
TABLE OF
Important Safety Instructions ...................... 2
Product Registration ................................... 3
Features at a Glance ................................... 4
Operating Instructions ............................. 4-6
Preparing and Loading Dishes .................. 6-8
www.frigidaire.com USA 1-800-944-9044
CONTENTS
Dishwasher Dispenser and Detergents ......... 9
Factors Affecting Performance ................... 10
Major Appliance Warranty ......................... 16
www.frigidaire.ca Canada 1-800-265-8352
Z
>
r-.J co
4b.
c)
_o
db
3>
O
>
o_
;o
db
<
oo
r-d
"2
ea
o_
u1
v
Please read all instructions before using this
dishwasher,
For your Safety
Use your dishwasher only as instructed in this Use and Care Manual.
This Manual does not cover every possible condition and situation that may occur.
Use common sense and caution when installing, operating and maintaining any
appliance. NSF certified residential dishwashers
are not intended for licensed food establishments.
DISHWASHER MUST BE ELECTRICALLY GROUNDED. Read the Installation Instructions for details.
This dishwasher is designed to operate on regular house current (120V, 60Hz). Use a circuit equipped with a 15 ampere fuse or circuit breaker. Use a 20 ampere fuse
if dishwasher is connected with a food disposer.
Do no operate dishwasher unless all enclosure panels are in their proper place.
To avoid entrapment and/or suffocation, remove door or door latch mechanism from
any dishwasher that is discarded or not in
use,
Keep young children and infants away from dishwasher when it is operating.
Do not let children abuse, sit, stand or play on door or racks of a dishwasher.
Use only detergents and rinse agents recommended for use in a dishwasher.
Store dishwasher detergent and rinse agents out fo the reach of children.
Do not wash plastic items unless marked:
"Dishwasher Safe" or equivalent. Check
with manufacturer for recommendations, if not marked. Items that are not marked
dishwasher safe may melt and creat a potential fire hazard.
Disconnect electrical power to dishwasher before servicing.
If the dishwasher drains into a food disposer, make sure disposer is completely
empty before running dishwasher.
Repairs should be done by a qualified technician.
Do no tamper with controls.
Do not touch the heating element during or
immediately after
Use care unloading the dishwasher when the SANITIZE option has been selected. Contents may be hot to the touch
immediately after the end of cycle. Water vapor from the vent may be hot to
the touch when the SANITIZE option has
been selected. Use care and do not let small children play around or touch the
vent area of the dishwasher. When loading items to be washed:
Locate sharp items and knives so that
they are not likely to damage the door seal or tub.
Load sharp items and knives with the handles up to reduce the risk of cut-type
injuries.
Under certain conditions, hydrogen gas
may be produced in a hot water, system that has not been used for 2 weeks or
more. HYDROGEN GAS IS EXPLOSIVE. If
hot water system has not been used for such a period, before using dishwasher,
turn for several minutes This will
release any accumulated hydrogen gas.
HYDROGEN GAS IS FLAMMABLE, Do no smoke or use an open flame during this
time,
Do not store or use combustible materials, gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
To reduce the risk of fire, electrical shock or
injury when using your dishwasher, follow
the ab°ve bas!c precauti°ns •:..............................................................
This symbols will help alert you to such dangers as personal injury, burns, fire and
electrical shock..
ThankyouforchoosingFrigidaire
This Use & Care Guide is part of our commitment to customer satisfaction and
product quality throughout ther service life of your new appliance.
We view your purchase as the beginning of a relationship. To ensure our ability to continue serving you, please use this page to record important product information.
Purchase Date
Model Number
Serial Number Registering your product with Frigidaire
enhances our ability to serve you. You can register online at www,frigidaire,com or by dropping your Product Registration Card in the
mail.
Why Energy Efficient Units run long cycles: Several factors are important to washing PLEASE BE ADVISED: If you compare
dlshware The energy use of the dishwasher
! " " th s d shwasher to prev ous mode s, you
Was reduced by applying more of the factors that ............
don't use so much energy and less of the ones , _hat use more. As a resule, you will see that the near.
wash wc!es take !0nger......................................... .................
Very Important Information - Read
Before Operating Your Dishwasher!
Normal Operating Sounds
This dishwasher does not sound like most dishwashers - IT'S QUIETER.
Your dishwasher with it's Precision Direct Wash System has many enhancements to
reduce it's sound level. Still, it is normal to
hear some of what is going on inside. The wash cycles include several instances of water entering the unit (splashing), the wash
pump running to spray water on the dishware
(motor & splashing) and the drain pump
running to discharge the dirty water and soils. Variations in the pumping/spraying sounds are
normal. During a cycle the pump switches on and off many times, and operation switches
back and forth between wash arms to provide the best cleaning performance.
may De surprlsea at wnat you UUl_l /
The dishwasher is programmed to remember your last cycle so you do not have to reset
each time. To start the dishwasher using the same cycle and options selected on the
previous wash, just press the START/CANCEL
Not all cycles and options available on all
mode s
Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms against soiled surfaces. First, the dishwasher fills with water covering the filter area. Water is then pumped through the spray arms. Soil particles go through and across the filter and down the drain as the water is pumped out. This series of steps are repeated as needed. The number of water fills vary with the cycle being used.
Nozzle or Spray Arm
Rack
Middle Spray Arm
Lower Spray Arm
Overfill
Deter(
Features may vary according to model
Operating Instructions
Getting Started
1. Load Dishwasher (See Preparing and Loading Dishes).
2. Add detergent (See Dishwasher Dispenser
& Detergents).
3. Add Rinse Aid, if needed (See Rinse Aid).
4. Close door to latch.
5. Select desired CYCLE (See Cycle Chart). The indicator light above the pad will glow
when selected.
6. Select desired OPTION (See Energy Options). The indicator light above the pad
will glow when selected.
7, Run hot water faucet nearest dishwasher until water is hot, Turn water off.
8. To start, press START/CANCEL pad.
Serial LaDe]
Silverware Basket
Glass Trap
Heating Element
Right)
Aid
Wash Cycle Selections
Cycle times are approximate and will vary with options selected. Hot water is necessary to
activate dishwasher detergent and melt fatty food soils. An automatic sensor will check
the incoming water temperature and, if it is
not hot enough, the cycle will be lengthend for automatic water heating in the main wash
and final rinse of all cycles. This happens even when HI-TEMP WASH option has not be
selected. When HI-TEMP WASH is selected, an even higher temperature will be reached to
handle heavier soil loads.
Option Selections
Hi-Temp Wash Option
When HI-TEMP WASH option is selected, the dishwasher heats water in the main wash to
approximately 140°F (60°C). This increase in water temperature helps the
dishwasher detergent remove food grease and soil from dishes more effectively and aids in
drying. HI-TEMP WASH option can be used with all cycles except RINSE ONLY. HI-TEMP WASH
isautomatically provided when the HEAVY
WASH cycle is selected. When HI-TEMP WASH option is selected, the
light above the pad will come on and remian on until end of cycle. To turn off the HI-TEMP WASH option, press the pad a second time. The light above the pad will turn off.
Sanitize Option
To sanitize your dishes and glassware, select SANITIZE option. When selected, the light above the pad will come on and reamin on until end of cycle. The water temperature inthe final rinse will be raised to 155°F (68°C) and will maintain that temperature for 9 minutes. This option is available in Heavy and Normal Cycles. Only these sanitization cycles have ben designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing
action will continue during the water heating delay. For best results, the incoming water temperature should be at least 120°F (49°C).
The sanitize criteria may not be satisfied if there
isan interruption of the cycle, power failure or if the incoming water temperature is below 120°F
(49°C). To turn off the SANITIZE option, press the pad
a second time. The light above the pad will turn off.
Delay Start
The DELAY START option allows you to automatically delay starting your dishwasher
from 2-4-6 hours. To activate delay start option, press the pad
once for a 2 hour delay, twice for 4 hours and three times for 6 hours. A light will come on
indicating the delay start hours and will remain on until cycle starts.
To cancel the DELAYSTART option and begin the cycle before the delay period is over, press the START/CANCEL pad.
Air Dry
When AIR DRY is selected the heater will be de-activated during the drying phase of the
selected wash cycle. This will slightly lower the energy use but will increase the likelihood that the dishware will not dry completely. If
AIR DRY is not selected the heater will be activated during the drying phase of the
selected wash cycle.
Child Lock Controls
To prevent children from accidently changing the dishwasher cycle or starting the dishwasher, lock the dishwasher controls by pressing and releasing the AIR DRY pad for 8 seconds while the door is open. An indicator light on the lock graphic pad will
illuminate when the controls are locked and no new selections can be made until the lock is
released. To unlock the controls, press the AIR DRY pad until the indicator light goes out.
To Cancel a Cycle
You can cancel a cycle anytime during the cycle. Press START/CANCEL pad and the
dishwasher will start a 90 second drain. At the end of the drain, select the next desired cycle.
Status Indicator Lights
The WASHING light comes on at the beginning of the cycle and remains on until the end of
the main wash. Whether heated or unheated dry is selected
the DRYING light will come on during the drying portion of the cycle.
When the SANITIZE option is selected, the SANITIZED light will glow when the SANITIZE cycle is finished. If the dishwasher did not
properly sanitize the dishes, the light will not
come on. This can happen if the cycle is
interrupted. The light will remain on until the
door is opened. The CLEAN light will come on at the end of
cycle and remain on until the door is opened.
The DishSense TMTechnology checks the soil
level on your dishes in the HEAVY WASH, NORMAL WASH and TOP RACK cycles. Depending on soil level, the sensor will
determine if additional water fills are needed to clean the dishes or if water fills can be deleted. Cycle time and water usage will
vary based on the amount of soil on the dishes. Cycle time will also vary based on the options selected and the incoming water temperature.
Loading...
+ 11 hidden pages