Frigidaire GLGT1142FS2, GLET1142FS1 Owner’s Manual

Laundry Center Dryer Operating Instructions

OFF

AUTOMATIC

PRESS SAVER

40 50

TI_II[D DBY

Before Operating Your Dryer

Readyour Owner's Guide. It has important safety

andwarranty information. Italsohas many suggestions

for best drying results.

To reduce the risk of fire, electric

shock, or injury to persons, read the IMPORTANT
SAFETYINSTRUCTIONSin your owner's guide before
operating this appliance.

Operating Steps

Read Drying Procedures in your Owner's Guide. It

explains these operating steps in detail.

1. Prepare items for drying.

2. Check that tint screen is clean and in place.
3, Load the dryer. If desired, add a dryer fabric

softener sheet.

4. Close the dryer door.

5. Set Drying Temperatures control

6. Turn cycle selector clockwise to desired
setting.

7. Start dryer. Turn the Turn to Start control clockwise

to ON. Hold for I-2 seconds and release.

8. A signal will sound when the cycle ends.

9. Remove items immediately and hang orfold.

10. Clean lint screen after every load.

Temperature Selection

Always follow directions on fabric care
labels.

Toavoid fire hazard, do not useheat to

dry items containing feathers or down, foam rubber,
plastics, or similarly textured, rubber-like materials.
Use Air Fluff cycle only.

The REGULAR/WHITES-HIGH HEAT, PERM PRESS/

COLORS-MEDIUM HEA T,andDELICATES-MEDIUM
LOW HEAT and KNITS-LOW HEAT temperature

settings may be used with any cycle setting.

Cyde Selection

Turn cycle selector clockwise to desired cycle and
setting.

Each cycle ends with a cool down period. The heat
automatically turns off and the load continues to
tumble for 5-10 minutes. This reduces wrinkling and
makes items easier to handle during unloading.

Drying time varies depending on sizeand dampness of
load, weight and fabric type. Room temperature and
humidity, type of installation and electrical voltage or
gas pressure can also affect drying time.

Printed in U.S.A. P/N134808900(0611)

Cycle Selection (continued)

Automatic Dry Cyde

* TOWELS - This setting is best for towel loads.

Select the REGULAR/WHITES--HIGH HEAT
temperature setting.

* NORMAL - This setting is best for cotton items.

Select the REGULAR/WHITES--HIGH HEAT
temperature setting.

* DELICATES/PERM PRESS-This setting isbest for

delicate, knit, or perm press items. Select the
PERM PRESS/COLORS--MEDIUM HEAT

temperature setting for permanent pressitems, the
KNITS---MEDIUM-LOWtemperature settingfor most

knit items, or the DELICATES--LOW HEAT
temperature setting for delicate items.

• Occasionallyaloadmayseemtoo damp oroverdried
at the end of the cycle. To increase drying time for

similar loadsin the future, setthe cycle selector on
the indicator line to the left of the TOWELS,

NORMAL, or DELICATES/PERMPRESSsetting. For
loads requiring less drying time, set the cycle

selector on the indicator line to the right.

• DAMPDRY-This setting isbest for itemsyou wish
to partiallydry before hanging or iron ing. Selectthe

temperature setting most suitable for the load.

Press Saver-If the dried load cannot be

removed promptly at the end of the cycle, the

cycleselectorwill automatically advance to the
PressSaver setting if the Press Saver option is

turned ON. Unheated tumbling continues for up
to24 minutes to help reducewrinkling. Thetimer

will not automatically advance into the Press
Saversetting if the Press Saver option isturned

OFF,

Note: Press Saver can be used independently for

up to 15 minutes of unheated tumbling to help
remove wrinkles from items that are already dry.

Turn selector knob to PressSaverand start dryer.
It is not necessary to set Temperatures or Press
Saveroption controls.

Air Fluff Cycle

This cycle provides up to 20 minutes of tumbling
without heat. UseAIRFLUFFto dry itemscontaining
feathers or down, foam rubber, plastics,or similarly
textured, rubber-like materials, to freshen clothing,
pillows or blankets, or to dust draperies.

Timed Dry Cycle

This cycle provides approximately 80 minutes of
drying time at the temperature selection of your

choice.

Energy Saving Tips

• Keep the lint screen clean and exhaust the
dryer correctly.

Sort laundry properly and select proper

temperature and cycle settings. Choose

an automatic dry cycle whenever possible

for accurate drying time.

• Dry only full loads. Single items and small
loads usually take longer to dry.

• Avoid overloading, adding wet items to a
partially dry load, and overdrying.

Dry one load after another to take
advantage of a warm dryer.

Opening the door needlessly causes warm
air to escape, which prolongs drying time.

If possible, use the dryer on low humidity
days.

Install the dryer in an area where the room

temperature is at least 45°F (7°C).

P/N134808900 (061 I)

Washer Operating Instructions Laundry Center

WASH/_NSE TEbSPERATU F_IE

_d'_ARB_ C©LD

_?AFM COLD

% @

Before Operating Your Washer

ReadyourWasherOwner's Guide. It has importantsafety

and warranty information. It also has many suggestions for
best washing results.

To reduce the risk of fire, electric shock, or

injury to persons, read the IMPORTANT SAFETY INSTRUC-
TIONS in your Washer Owner's Guide before operating this

appliance.

Operating Steps

Read Washing Procedures in your Owner's Guide. It

explains these operating steps in detail.

1. Sort laundry into loads that can be washed together.

2. Prepare items for washing,

3. Pretreat stains and heavy soil.

4. Addthemeasuredamountofdetergenttowashtub
before adding the laundry load.

5. If desired, add liquid bleach to bleach dispenser. DO

NOT pour bleach directly onto the load.

Printed in U.S.A.

LOAD SIZE

I_ED_UM PREWASH

I r)/,D

6. If desired, add liquid fabric softener to fabric
softener dispenser. DO NOT pour fabric softener

directly onto wash load.

7. Add laundry load loosely to wash tub. Dry load
should not be higher than top of agitator vanes.

For best results, DO NOT overload.

8. Select the wash cycle and settings according to type,
size and soil level of each load.

SOAK/PREWASH

SOAK

SPIN

RINSE

KNITS/DELICATES

/_ULIf# :;_xv_ PERM PRESS COLORS
J/is// ,SoP PREWASH

O/7:

9. Close rid and pull out Cycle Selector knob to start

washer. Thewasher will fill with water but will not agitate

or spin with the lid open.

To stop the washer, push in the Cycle Selector knob. To

change a cycle, push in the Cycle Selector knob and turn
it clockwise to the desired setting. Puii out the knob to

restart the washer.

10. Remove items at end of cycle. Wait about 2-9 minutes
for safety lid lock to release

WHITES

RINSE

POWER SPIN

OFF

Cycle Selection

Push in and turn the Cycle Selector knob clockwise to
the desired cycle. For best results, follow the

washing instructions on the fabric care labels.

The Whites, Colors and Delicates cycles progress through
wash agitation, drain and spin with a spray rinse, rinse

agitation, and a spray rinse during the final spin.

Whites Cycle

This cycle provides up to 15 minutes of normal agitation and

a fast spin for most fabrics.

Power Spin provides 12 minutes of spin for maximum
removal of water This conserves energy by reducing drying

time.

Extra Rinse Cycle

Use the Extra Rinse cycle after any complete wash cycle

when an additional deep rinse may be needed to remove

excess detergent and soil. It provides 3 minutes of rinse
agitation in cold water, followed by a spray rinse at the
selected rinse water temperature during spin.

If desired, add liquid fabric softener to the rinse water or use
a softener sheet in the dryer. DQ NQT pour fabric softener

directly onto the load.

P/N134808900 (061 I)