Frigidaire GLGT1031FS1, FLGB8200FS3, FLGB8200FS2, FLGB8200FS1, FLEB8200FS1 Owner’s Manual

DRYER OPERATING INSTRUCTIONS

TIMED DRY

COOL DOWN

50'

70 COOL

START

LESS DRY

DOWN

AUTOMATIC

PERM PRESS

PRESS SAVER ! FABRIC SENTRY

AUTOMATIC

REGULAR

Before Operating Your Dryer

Readyou rOwner's Guide. Ithas important safety and

warranty information. Italso hasmany suggestions for

best drying results.

To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETYINSTRUCTIONSin your owner's guide before

operating this appliance.

Operating Steps

Read Drying Procedures in your Owner's Guide. It explains these operating steps in detail.

1. Prepare items for drying.

2. Check that lint screen is clean and in place.

START

3. Load the dryer. If desired, add a dryer fabric softener sheet.

4. Closethe dryer door.

5. SetTemperature controls.

6. Turn cycle selector clockwise to desired setting.

7. Start dryer. Turn Start control clockwise to ON. Hold for 1-2 seconds and release.

8. A signal will sound when the cycle ends.

9. Remove items immediately and hang or fold.

10. Clean lint screen after every load.

TEMPERATURE

KNITS/DELICATES PERM PRESS

LOW HEAT MEDIUM HEAT

AIR FLUFF = • REGULAR

NO HEAT HiGH HEAT

Temperature Selection

Always follow directions on fabric care labels.

_To avoid fire hazard, do not useheat to dry items containing feathers or down, foam rubber,

plastics, or similarly textured, rubber-like materials. Use Air Fluff-No Heat setting only.

The REGULAR-HIGH HEAT, PERM PRESS-MEDIUM HEAT,and KNITS/DELICATES-LOWHEATtemp-eratu re settings may be used with any cycle setting. The AIR FLUFF-NOHEATsetting can be used only in the Timed Dry cycle.

AIR FLUFF-NOHEATsetting tumbles the load without heat. Use Air Fluff to freshen clothing, pillows or blankets, or to dust draperies.

The dryer hasa 5.7kg/121b dry clothes drying capacity.

Printed in U.S.A. P/N134808800(0611)

COOL DOWN

40 e i

50 •

TIMED DRY DOWN

70 COOL

START

LESS DRY

AUTOMATIC

PERM PRESS

PRESSSAVER!

FABRIC SENTRY

AUTOMATIC

REGULAR

START

TEMPERATURE

KNITStDEUCATES PERM PRESS

LOW HEAT MEDIUM HEAT

AIR FLUFF = = REGULAR

NO HEAT HiGH HEAT

Cycle Selection

Turn cycle selector clockwise to desired cycle and

setting.

Each cycle ends with a cool down period. The heat automatically turns off and the load continues to

tumble for 5-10 minutes. This reduces wrinkling and

makes items easierto handle during unloading.

Drying time varies depending on size and dampness of load, weight and fabric type. Room temperature and

humidity, type of installation and electrical voltage or gas pressure can also affect drying time.

Automatic Perm Press/Deficates Cycle

This cycle isbest for permanent press, knit and delicate

items. Drying time isdetermined automatically at the

temperature selection of your choice.

., Medium heat is suggested for permanent press

items.

• Low heat issuggested for knit and delicate items.

Ifthe dried load cannot beremoved promptly, the cycle selector will advance to the PressSave#Fabric Sentry

setting. Unheated tumbling continues during Press Saver/Fabric Sentry for approximately 30 minutes to

help reduce wrinkling.

The cycle signal will sound briefly every 5 minutes asa

reminder to remove the load.

A utoma tic Regular Cycle

This cycle is best for cotton items that can be tumble dried.

Drying time is determined automatically at the temperature selection of your choice. This cycle is best for items of similar fabric, weight and construction.

• For items requiring more drying time, set cycle selector on MOREDRY.

• Foritems requiring lessdrying time, set cycleselector on LESSDRY.

Timed Dry Cyde

This cycle provides upto 70 minutes of drying time at the temperature selection of your choice.

Energy Saving Tips

., Keep the lint screen clean and exhaust the dryer

correctly.

• Sort laundry properly and select proper temperature and cycle settings. Choose an automatic dry cycle

whenever possible for accurate drying time.

• Dry only full loads. Single items and small loads usually take longer to dry.

• Avoid overloading, adding wet items to a partially dry load, and overdrying.

• Dry one load after another to take advantage of a

warm dryer.

., Opening the door needlessly causes warm air to

escape,which prolongs drying time.

• If possible, usethe dryer on low humidity days.

., Installthe dryerinanareawhere the room temperatu re

is at least 45°F (7°C).

P/N134808800 (0611)

LAUNDRY CENTER WASHER OPERATING INSTRUCTIONS

WASH/RiNSE TEMPERATURE

COLD COLD

COLD • e COLD

HOT 0 WARM

Before Operating Your Washer

Readyour Washer Owner's Guide. It has im porta nt safety

and warranty information. It also has many suggestions for best washing results.

To reduce the risk of fire, electric shock, or

injury to persons, read the IMPORTANT SAFETYINSTRUC- TIONSin your Washer Owner's Guide before operating this

appliance.

Operating Steps

Read Washing Procedures in your Owner's Guide. It

explains these operating steps in detail.

1. Sort laundry into loads that can be washed together.

2. Prepare items for washing.

3. Pretreat stains and heavy soil.

4. Addthemeasuredamountofdetergenttowashtub before adding the laundry load.

SOAK/

LOAD SiZE

MEDIUM

SMALL ® LARGE

6. If desired, add liquid fabric softener to fabric softener dispenser. DO NOT pour fabric softener

directly onto wash load.

7. Add laundry load loosely to wash tub. Dry load should not be higher than top of agitator vanes.

For best results, DO NOT overload.

8. Select the wash cyde and settings according to type, size andsoil level of each load.

PREWASH is 12

SOAK

RINSE

KNITS/

DELICATES 6 FINALSPIN

9. Close lid and pull out Cycle Selector knob to start

washer. The washer will fill with water but will not agitate

or spin with the lid open.

To stop the washer, push in the Cycle Selector knob. To

change acycle, push in the Cycle Selector knob and turn it clockwise to the desired setting. Pull out the knob to

restart the washer.

10. Remove items at end of cycle. Wait about 2-3 minutes for safety lid lock to release.

WHITES

PREWASH

RINSE

FINAL SPIN

SPIN

_e12

®4

COLORS

Cycle Selection

Push in and turn the Cycle Selector knob clockwise to the desired cycle, For best results, follow the

washing instructions on the fabric care labels,

The Whites, Colors and Knits/Delicates cycles progress

through wash agitation, drain and spin with a spray rinse, rinse agitation, and a final spin.

Whites Cycle

This cycle provides up to 15 minutes of normal agitation and

a fast spin for most fabrics.

Colors Cyde

This cycle provides up to 12 minutes of normal agitation

and a fast spin for cottons and blends with a no-iron finish. A cool down spray rinse helps reduce wrinkling.

5. If desired, add liquid bleach to bleach dispenser. DO NOT pour bleach directly onto the load.

Printed in U.S.A.

P/N134808800 (0611)

+ 5 hidden pages