Frigidaire FWC342GB Owner’s Manual

ieps ......................... 3
Energy Saving Tips .................. 4
Setting
the Temperature ControJ ............. 4
Wine Cooler Features ............. 4
Care and Cleaning .................... 5
Warranty ............................... 6
Troubleshooting Guide ........... 7 =8
READ AND SAVE THESE INSTRUCTIONS P/N:241846000(Mar2007)
READ AND SAVE THESE INSTRUCTIONS
This Owner's Guide provides specific operating instructions for your model Use your Wine Coobr onUyas instructed in
sense and caution must be practiced when installing, operating, and maintaining any appliance,
Record Your Model and SedaJ Numbers Record the model and serial numbers in the space provided
below, The serial plate is located on the upper left wall inside the Wine Cooler,
be plugged directly into a properly grounded three- prong receptacle, The receptacle must be installed in
accordance with local codes and ordinances, Consult a qualified electrician, Do not use an extension cord or
adapter plug.
o if voltage varies by 10% or more, performance of your
wine cooler may be affected, Operating wine cooler with insufficient power can damage the compressor,
To prevent the wine cooler from being turned off accidentically, do not plug unit into an outlet controlled
by a wall switch or pull cord,
Do not pinch, knot, or bend the cord in any manner,
r':"w-'_:;_'"_'[eOT HE R PRECAUTIONS
Modet Number:
SedaJ Number:
Purchase Date:
READ ALL INSTRUCTmONS BEFORE USING
THIS WmNE COOLER.
r','v,v:_:;_,l,,€_ FOR YOUR SAFETY
Do not store or use gasoline, or other flammable vapors and liquids in the vicinity of this or any other appliance, Read product labels for flammability and other warnings,
[!_l"/:IIi_ll_{€I CHILD SAFETY
o Destroy carton, plastic bags, and any exterior wrapping
material immediately after the wine cooler is unpacked, Children should never use these items to play, Cartons covered with rugs, bedspreads, plastic sheets or stretch wrap may become airtight chambers, and can quickly cause suffocation,
Remove all staples from the carton, Staples can cause
severe cuts, and destroy finishes if they come in contact with other appliances or furniture,
An empty, discarded ice box, refrigerator, or freezer is a very dangerous attraction to children,
Remove the door(s) of any appliance that is not in use, even if it is being discarded.
F;_'*v-'_:;_''i'[_ELECTRICAL INFORMATION These guidelines must be followed to ensure that safety
mechanisms in the design of this wine coobr wilt operate property.
o Wine Cooler must be ptugged into its own 115 Volt,
60 Hz., AC only etectric outbt. The power cord of the appliance is equipped with athree=prong grounding
plug for your protection against shock hazards, it must
Never unplug the wine cooler by pulling on the cord, Always grip the plug firmly, and pull straight out from the receptacle,
Toavoid electrical shock, unplug the wine cooler before cleaning and before replacing a light bulb,
NOTE: Turning the temperature control to OFF turns off the compressor, but does not disconnect the power to the light bulb or other electrical components,
o Do not operate wine cooler in the presence of explosive
fumes,
Proper Disposa{ of YourWine Cooler
_'!_v,V:W:t#1I#[€
and suffocation are not problems of the past. Junked or abandoned Wine Coolers are still dangerous -- even if they will sit for "just a few days." if you are getting rid of your oId wine cooler, please follow the instructions below to help
3revent accidents.
WiNE COOLER:
Remove doors.
BEFOREYOUTHROWAWAYYOUR OLD _
'_ Leave sheives in place so children may not
easily climb inside.
r!VAV_q:_I_II_[€
Avoid fire hazard or electric shock. Do not use an extension cord or an
adapter plug. Do not remove any prong
from the power cord.
Risk of child entrapment. Child entrapment
Grounding type wall receptacb
Power supply cord with 3-prong grounding p_ug
REVERSING THE DOOR SWING
This Owner's Guide provides specific operating instructions for your model Use the refrigerator oniy as instructed in this Owner's Guide, Before starting the wine cooler, foltow these important first steps.
INSTALLATION o Choose a piace that is neara grounded eHectrbaHoutiet,
Do Not use an extension cord or an adapter piug,
o For optimai performance, it is recommended that you
instali the wine cooler where the ambient temperature is between 70 and 78 degrees fahrenheit,
Alfow space around the unit for good air circulation,
Leave a 2 inch space on the back and sides of the
wine cooler for adequate circulation,
Be sure the wine cooler stays in the upright position
o Keep the wine cooler from any hazardous or combustibie
agents,
NOTE: The exterior walis of the wine cooler may become quite warm as the compressor works to transfer heat from
the inside, Temperatures as much as 30° Fwarmer than
room temperature can be expected, For this reason it is particulariy important in hotter ciimates to allow enough
space for air circulation around your wine cooler,
LEVEMNG The wine cooler must have all bottom corners resting firmly
on solid floor, The floor must be strong enough to support a fuliy ioaded wine cooler, NOTE: it is Very Important for
your wine cooler to be ievei in order to function properiy, if the wine cooler is not ieveled during installation, the door
may be misaligned and not choseor seai properiy, causing cooling, frost, or moisture probiems,
The wine cooler glass door can be opened from left to right and vice versa, Should you desire to change the opening direction, please follow these instructions,
NOTE: All parts removed must be saved to do the reinstallation of the door,
1, Remove the two screws (1) that hold the lower hinge
(2)(right side) to the frame, Also remove the screw-type leveling front leg (3),
2, Remove the left front leg (4) and transfer it to the right
side,
3, Lift the door and place it on a padded surface to prevent
scratching it, Make sure to remove the spring (5) located inside the upper right hob of the door, and the upper right side pin (6),
4, Remove the plug button (7) from the upper left hob of
the door and transfer it to the uncovered hob on the right side, Be sure to press the button firmly into the hob,
5, insert the upper pin (6), previously removed from the
right side in step 3, and transfer it to the hob on the left side of the top frame,
6.
insert the spring (5), previously removed from step 3,inside the upper left side hob of the door,
7,
Set the door in its place making sure the pin (6) enters the bushing at the lower upper frame section (hob),
8,
While holding the door in the closed position, secure the left hinge (2) previously removed in step 1,
9,
insert the 2 screws (1) previously removed in step 1 and tighten them,
F---5
_6
J
7
To LeveJYourWine Coobr: After removing ali interior and exterior packaging materiais,
use a carpenter's ievei to ievei the wine cooler from front-to- back, Adjust the ieveling iegs in front, _ bubbie higher, so that the door doses easiiy when Hefthaifway open,
CLEANING
Wash any removable parts of the wine cooler interior, and exterior with mild detergent and warm water, Wipe
dry, Do not use harsh cleaners on these surfaces.
Do not use razor blades or other sharp instruments, which can scratch the appliance surface when removing adhesive labels, Any glue left from the tape can be
removed with a mixture of warm water and mild deter- gent, or touch the residue with the sticky side of tape
already removed, Do not remove the seria! plate.
important Safeguards: Do not store food in your wine cooler as interior temperature may not get cool enough to prevent spoilage, in summer months or areas of high humidity, the glass door may build up moisture, To
remove the moisture, wipe it away,
Y
4
FIGURE 1
PosWon prior to door reversal
1 Door Hinge Screws
2 Lower Door Hinge
3 Front Leveling Legs 4 Left Front Leg 5 Door Frame Spring
6 Door Frame Pin
7 Hinge Plug (Door Frame) Left Side
FIGURE 2
PosWon prior to door reversal
Loading...
+ 5 hidden pages