Frigidaire FTF1240FS1, FTF1240FS0 Owner’s Manual

OPERATING INSTRUCTIONS
WASH/RINSE TEMPERTURES
_ WARM COLD
COLD COLD
HOT WARM _
WARM6
YES NO NORMAL FAST
erecisionTemp°,:
CONIROL
Before Operating Your Washer
Read your washer Use and Care Guide. It has
important safety and warranty information. It also has many suggestions for best washing results.
To reduce the risk of fire, electric shock,
or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONSin your washer Use and Care Guide before operating this appliance.
ONil
DOORLOCK
3. Pretreat stains and heavy soil.
4. Add laundry load to the wash drum,
Open the dispenser drawer and add the
measured amount of detergent to the detergent compartment. If desired, add liquid
bleach and fabric softener to the appropriate compartments. Slowly close dispenser drawer.
Drawer should be completely closed for laundry additives to dispense,
KNITS/DELICATES
PULL TO START/ PUSH TO STOP
END OF CYCLE
SIGNAL
/
\'\ /
WASH
OFF
FINAL SPIN
OFF
EXTRA CARl
WASH
COLORS
10.
Start the washer by closing the door and
FINAL SPIN
O FF
pulling out the cycle selector knob, The
washer will not operate with the door open. As a safety measure, the door will
automatically lock during the entire wash cycle. When the door is closed, the Door Lock
Indicator lights up when the washer starts, and turns off at the end of the cycle.
To stop the washer, push in the cycle selector knob.
WHITES
HEAVYWASH
_INAL SPIN
SHORT
WASH
Opera ring Steps
Read and follow Washing Procedures in your Use and Care Guide. It provides detailed information for
preparing the wash load and choosing control settings to ensure best washing results.
1. Sort laundry into loads that can be washed
together,
2. Prepare items for washing.
Printed in U. S. A.
6. Set Temperatures switch according to fabric type and soil level of each load.
7. If desired, select Extra Rinse in Whites/
Regular, Colors/Perm Press, or Delicates cycle.
8. Select Final Spin Speed as desired.
9. Push in the cycle selector knob and turn it
clockwise to the desired wash cycle and setting.
To change a cycle, push in the cycle selector knob and turn it clockwise to the
desired setting. Pull out the knob to restart the washer.
1I. Remove items when cycle ends. A signal
will sound at the end of the cycle when the Cycle Signal ON is selected.
Note: From time to time you may seewater in the bleach and fabric softener compartments. This is a result of the siphoning action and is
part of the normal operation of the washer.
P/N 137009100 (0710)
iiii
Cycle Selection
For best results, follow the fabric care label directions on items to be washed.
Whites/Regular Cycle
Up to 18 minutes of reversing tumble action for most fabrics. Three rinses, two spins, a pause and a brief
tumble complete the cycle. Select NORMAL or FAST Final Spin asdesired.
HeavyWash provides up to 18 minutes of reversing tumble action for heavily soiled fabrics.
Wash provides up to 13 minutes of reversing tumble action for normally soiled fabrics.
Light Wash provides up to 6 minutes of reversing tumble action for lightly soiled fabrics.
Short Wash Cycle
Savestime and water. Up to 6 minutes of reversing tumble action for very lightly soiled fabrics. Two rinses, two spins, a pause and a brief tumble complete the cycle. Extra Rinse is not an option with
this water conserving cycle. Select NORMAL or FAST Final Spin as desired for this cycle.
Colors/Perm Press Cycle
Up to 13 minutes of reversing tumble action for cottons and blends with a no-iron finish. Three rinses,
two spins, a pause and a brief tumble complete the cycle. Select NORMAL or FAST Final Spin as desired
for this cycle.
Wash provides up to 13 minutes of reversing tumble action for heavily soiled fabrics.
Extra Care provides up to 6 minutes of reversing tumble action for lightly soiled fabrics.
Controls
Always follow instructions on fabric care labels. Note: There is no need to select a water level
because the washer automatically adjusts the
water level to the type and size of wash load.
TEMPERATURES- This determines water temperatures
for washing and rinsing. For example, the Warm/Cold setting provides awarm water wash and a cold water
final rinse. Note: Detergents are not aseffective at wash water
temperatures below 65% (18.3°C). The following chart suggests wash/rinse temperatures
for basic fabric types.
Wash/Rinse
Fabric Type
Heavily soiled white/colorfast
cotton, perm press
Normally soiled white/colorfast Warm/Cold
cotton, perm press
Lightly soiled/noncolorfast
fabrics, knits, delicates,
hand washables
Washable woolens Warm/A/arm
CYCLE SIGNAL - A signal will sound at the end of the cycle when the Cycle Signal isset to ON. This can be turned off by selecting OFFon the Cycle Signal switch.
Tempera ture
Hot/Cold
Cold/Cold
Precision Temp Control
The normal temperature of warm and cold wash water
can be affected by the hot water heater setting and seasonally low ground water temperatures in some
geographic areas. Sincedetergents work best in wash
water at aminimum of 65° F,select a Precision Temp
Controlto regulate the temperature of the warm and cold wash water in any cycle.
Wash water in the Warm/Cold and Warm/Warm
settings is regulated to approximately 82° F. and the
wash water in the Cold/Cold setting is regulated to
approximately 70° F. Rinsewater temperatures are not regulated.
EXTRA RINSE - Use Extra Rinsewhen additional
rinsing is desired to remove excessdirt and detergent
from heavily soiled loads.
Select Extra Rinse YESto automatically include
an extra rinse in Whites/Regular, Colors/Perm Press,or Delicates cycle.
Select Extra Rinse NO to conserve water when an extra rinse is not desired.
FINAL SPIN - There are two final spin speed options available for each cycle. Note: The speeds will vary
from cycle to cycle. For example, Regular Fast spin speed is much faster than Delicate Fast spin speed.
NORMAL isrecommended for most loads.
FAST provides a faster spin speed to increase
water extraction and decrease drying time.
Knits and Delicates Cycle
Up to 10 minutes of gentle tumble action for the gentle care of knit, delicate and hand washable items. Two rinses and two spins complete the cycle.
Select NORMAL or FAST Final Spin asdesired for this cycle.
When the door is closed, the Door Lock Indicator
lights up when the cycle selector knob is pulled out, and turns off at the end of the cycle.
P/N 137009100 (0710)
Loading...
+ 2 hidden pages