Frigidaire FRS28ZRGW3 Service Data Sheet

IMPORTANT SAFETY NOTICE

SERVICE DATA SHEET - 218877000

The information provided herein is designed to assist qualified repair
personnel only. Untrained persons should not attempt to make repairs due to
the possibility of electrical shock. Disconnect power cord before servicing.

IMPORTANT

ICE & WATER - AUTOMATIC DEFROST

SIDE BY SIDE MODELS

R134a

If any green grounding wires are moved during servicing, they must be returned to their original position and properly secured.

CAUTION

System parts must be removed from cabinet before brazing. All electrical parts and wiring must be shielded from torch flame. Do not
allow torch to contact insulation; it will char at 200°F and flash ignite (burn) at 500°F. Excessive heat will distort the plastic liner.

ATADECNAMROFREP

roticapaCtratS/nuRhtiWAepyTtneibmAF°56tneibmAF°09

emiTgnitarepO%54ot73%86ot06

erutarepmeTrezeerFF°4ot°0F°3ot°2-

erutarepmeTerutaregirfeRF°93ot°43F°93ot°43

)ni-tuc(erusserPediSwoLgisp21ot5gisp21ot5

))tuo-tuc(erusserPediSwoLgisp2ot2-gisp2ot2-

)elcycfo3/1tsaL(erusserPediShgiHgisp031ot011gisp081ot051

)elcycfo3/1tsaL(egattaW002ot071012ot081

)gninnuR(spmA8.1ot5.18.1ot5.1

egatloVesaBCAV511CAV511

SNOITACIFICEPSTSORFED

eziStenibaC

'82ot'22F°52+F°74+00622

sttaWMPRspmA

3.2tfahSetisoppOWC0031gninnuR51.

lacirtcelEstloV511ztreH06

tatsomrehTF°84tasnepOF°51tasesolC

egattaWretaeH561

ni-tuCtuo-tuCsttaWsmhO

tatsomrehTretaeH

emiTnuRrosserpmoCfosruoH8yrevEsetuniM03tsorfeD

ROTOMNAFRESNEDNOC

REPMADCITATSOMREHT

nepOlluFdesolC

F°2-/+F°33F°2-/+F°22

SNOITACIFICEPSREKAMECI

GNITTESLORTNOCTNIOP-DIMTASGNINEPOROODONDNADAOLON

ICE MAKER INFORMATION

Test Cycling

Remove cover by inserting screwdriver in notch at
bottom and prying cover from housing. Use
screwdriver to rotate motor gear counterclockwise
until holding switch circuit is completed. All
components of ice maker should function to
complete the cycle.

Water Fill Volume

The water fill adjustment screw will change the fill
time. One full turn is equal to 20cc (.68 oz.). The
correct fill is 90 to 120cc (3.0 to 4.0 oz.). When a
water valve is replaced, the fill volume must be
checked.

WIRING DIAGRAM

LADDER DIAGRAM

ICE/WATER DISPENSER