Frigidaire Fn30ngdc, Fn30lpdc Owner's Manual

tructions ...... 2

& Components .... 3°4

Gas Requirements

Leak Testing ................. 13-15

Using the Grill

Lighting the Grill ................. 17

Care & Maintenance ............. 20

Before You CaJm

Trouble Shooting ............. 21=22

Visit the Frigidaire Web Site at:

Warranty .......................... 23

http ://www.frig idai re.corn

(( )))q

READ AND SAVE THESE fNSTRUCTIONS =MADE fN THE U.S.A.

........... 16o19

Congratulations on your purchase of a new gas grill! At Electrolux Home Products, we are very proud of our product and are completely committed to providing you with the

best service possible. Your satisfaction is our number one priority.

We know you'll enjoy your new gas grill and Thank You for choosing our product. We hope you consider us for future purchases.

PLEASE CAREFULLY READ AND SAVE THESE INSTRUCTIONS

This Use & Care Manual provides specific operating instruction for your model. Use your gas grill only as instructed in this manual. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be

practiced when installing, operating and maintaining any appliance.

Questions? 1-800-320-0859

Please record Grill information for future reference and service work:

Model #:

Serial #:

Date of Purchase:

Gas Type:

Please retain this manual tbr thture reference

IMPORTANT SAFETY INFORMATION

- Read this manual carefully before using your grill to reduce the risk of file, burn hazaM or

other injury.

- Extreme cam should be used because of the high telnperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED.

- This appliance must be kept clear from combustible materials, gasoline or other flarnmable vapors and liquids. Do not allow flarnmable materials to come in contact with grate, burner or hot surfaces.

- Do not repair or replace any part of this appliance unless it is specifically recommended in this manual. A qualified service techni- cian should conduct all other service.

- Follow the installation and servicing instructions provided with this product. Have your grill installed by a qualified service techni- cian. Locate the main gas supply valve so that you know how to shut the gas off to your grill. If you smell gas, make sum all gas connections are tight before operation. If you continue to smell gas call a qualified technician.

- When lighting a burner, always pay close attention to what you am doing. Be certain you are pushing the ignitor that lights the burner you intend on using.

:ures FN3

Roll top grill hood

Grilling/Cooking surface

Side Shelves

Control knobs: main burners

Convection vents

6. Handle

7. Warming shelf

8. Electronic ignitor

9. Ignitor access opening

10. Cart w/door

Note:

Prior to assembly remove protective film from stainless steel parts

Cart Assemblw Door Stops & Door Pivot Bolts

1. Attach the two L-shaped sides to the back portion

of the cart, making sure the two holes face up & the key holes are on the top, using the (4) self tapping hex head screws. (See Fig. 1)

Fig. 1

Wheel Channel

Fig. 2

Note: A power screwdriver is required to install the

screws-be cautious not to over-tighten and strip the screws.

Set the base on the top of the cart assembly, with large opening closer to back portion of cart, and align the eight mounting holes. Then set the 2 wheel channels on the base and attach them using the (8) bolts provided, from inside the cart

upwards through wheel channels. (See Fig. 2)

Note:

Tighten the bolts securely

Door Stop: Insert Door Stop Bolt downward

from bottom side of Cart Base through the hole found in the right/front of the base. (See Fig 3)

Screw Rubber Cap onto Bolt from the topside of Cart Base and tighten securely. (See Fig 4)

. Door Pivot Bolt: Insert Bolt downward from

bottom side of Cart Base through the hole %und

in the left/front of the base and secure with bolt. (See Fig. 2)

Fig. 3

Fig. 4

Attaching Grill Head to Cart

1. While keeping the Grill on the foam base lean it onto its back. (be sure to hold the

hood shut when doing this.) With the Grill on its back, loosen all 4 bolts on the bottom side of the Grill, but do not

relnove.(See Fig. 5)

Using 2 self tapping hex head screws, attach the magnetic door catch in the 2 holes

in the bottom of the grill. (See Fig. 6)

ttave someone help you pick up the grill and set it on the top of the cart, with the front of the grill above the door opening. Make

sure the 4 bolt heads fall through the large opening of the key hole slots in the top of the

cart. Slide the grill head backward, so the bolts are resting in the small opening of the key hole slots. Tighten the bolts securely.

Be sure not to over tighten and strip the bolts. Next insert 4 hex head screws into grill

bottom through cart. (See Fig. 7)

Screw hole for

naagnetic catch

Fig. 5

Fig. 6

Note: This is a very heavy step that requires

two individuals to complete.

Installing the Cart Door

While holding the door line up the bottom hole on the door with the bolt sticking up

through base of cart. Next place a nylon bushing onto the top pin, then depress the pin

and insert into the hole in the bottom of the grill. (See Fig. 8)

Fig. 7

Screw

Fig. 8

Installing the Cart Door Handles

Using a 5/32" allen wrench insert 1 screw through the inside of the door front into a bar handle end and tighten securely.

(See Fig. 9)

Insert Bar tlandle into the End Cap attached to the door and then into the

other End Cap and tighten End Cap with allen wrench and screw. (See Fig. 10)

3. Complete Door. (See. Fig. 11)

Backside of door: 2 screw locations

Fig. 9

Installing the Drip Tray

The drip pan is installed inside of the cart under the grill head.

Slide the drip pan onto the two ledges located on the bottom of the grill, by inserting it from the front of the cart. (See Fig. 12)

Fig. 10

Grill

Fig. 12

Fig. 11

+ 16 hidden pages