Frigidaire FMB330RGB0, FMB330RGC0, FMB330RGS0, FMP330RGB0, FMP330RGS0 Installation Guide

Installation

Bui It-In

Instructions

Dishwasher

If you have questions, call 800-944-9400(US),800-245-8352(Canada)or visit

our website at: www. Frigidaire.com

BEFORE YOU BEGIN

Read these instructions

completely and carefully.

IMPORTANT - Observeall

governing codes and ordinances.

• Note to Installer - Be sure to leave

these instructions for the consumer's and local inspector's

use .

• Note to Consumer -Keep these instructions with your Owner's

Manual for future reference.

• Skill Level - Installation of this

dishwasher requires basic mechanical and electrical skills. Proper

installation is the responsibility

of the installer. Product failure due to improper installation is not

covered under the ELECTROLUX

Appliance Warranty.

• Completion Time - 1 to 3 Hours. New installations require more time than

replacement installations.

IMPORTANT - Thedishwasher

MUST be installed to allow for future removal from the enclosure if service

is required. If you received a damaged dishwasher,

you should immediately contact your dealer or builder.

Optional Accessories - See the Owner's Manual for available custom panel

kits.

FOR YOUR SAFETY

Read and observe all CAUTIONS and WARNINGS shown throughout these

instructions. While performing installations described in this

booklet, gloves, safety glasses or goggles should be worn.

WARNING

Toreducetheriskofelectricalshock,fire,or injurytopersons,theinstallermustensurethat

thedishwasheriscompletelyenclosedatthe timeofinstallation.

READ CAREFULLY.

KEEP THESE INSTRUCTIONS.

Installation Preparation

PARTS SUPPLIED : " Two#8 Phillipsfiatheadwoodscrews,5/8"longtosecure

dishwashertoundersideofcountertop[iniiteruturapackage].

" TwoPhillipshead,colormatchedtoehichscrews[iniiteratura

package].

MATERIALS YOU WILL NEED:

" Ferrule,compressionnutand90°Elbow[3/8"HPTexternal

threadononeend,oppositeendsizedtofitwatersupply)

" Threadseaitape " ULListedwirenuts[3]

Materials for New

Installations Only:

- Airgapfordrainhose,ifrequired

" Wasteteeforhouseplumbing,ifapplicable " Electricalcableorpowercord,ifapplicable " Screwtypehoseclamps

" Strainraiiefforelectricalconnection " Handshut-offvalve

" Waterline3/8"min.copper " Goupierforextendingdrainiine_if applicable

2WoodScrews 26oiorMatched

ToehichScrews

90°Elbow,Ferrule andGompressionHut

WasteTee

AirGap

OffValve

ElectricalGable [orPowerGord,ifapplicable]

ScrewType StrainRelief HoseGiamps

ScrewType HoseGiamp

WireHuts[3]

Thread SealTape

HotWaterline

Gnupier

TOOLS YOU WILL NEED:

[] Phillipsheadscrewdriver [] 5/16"and1/4"nutdriver [] 6"Adjustablewrench

[] Level [] Garpenterssquara

[] Measuringtape [] Safetyglasses [] Flashlight [] Buckettocatchwaterwhenflushingtheline

[] Gloves

For New Installations

Only :

[]Tubingcutter

[] Driftandappropriatebits [] Holesawset

Phill_ Screwdriver

Flashlight

Gloves

Bucket

and5/16" Hutdriver

6"Adjustable Wrench

SafetyGlasses

HoleSawSet

Level

Garpeuters Square

I:,:,:,:,:,:,:,:,:,:,:,',,

TubingGutter

MeasuringTape

Installation Preparation

PREPARE DISHWASHER ENCLOSURE

32,5"

Undersideof

Countertop

toFloor

Square

17-5/8"Min, and

18"Max, Plumb

FigureA

PlumbingandElectricService

Must EnterShadedArea

• Theroughcabinetopeningmustbeatleast24"deepand

17-5/8"to18"wide.Theopeningshouldbe32.5"max.height.

DRAIN REQUIREMENTS

• Followlocalcodesandordinances.

• Donotexceed10feetdistancetodrain.

• Donotconnectdrainlinesfromotherdevicestothe

dishwasherdrainhose.

• Dishwashermustbeconnectedtowastelinewithanairgap

[notsupplied]or32"minimumhighdrainloop,dependingon

localcodesandordinancestopreventbackflowintothe dishwasher.

• Airgapmustbeusedif wasteteeordisposerconnectionis

lessthan18"abovethefloortopreventsiphoning.

DRAIN PREPARATION

Thetypeofdraininstallationdependsonanswerstothe followingquestions:

[] Dolocalcodesorordinancesrequireanairgap? [] Willwasteteeordisposerconnectionbelessthan18"

abovethefloor?

[] Willinstallationhaveadrainlooplessthan32"abovefloor?

iftheanswertoANYofthe3questionsaboveisY_s,

Method 1 MUST be used, OtherwiseeitherMethod1or

Method2maybeused.FigureCorFigureg.

• Thedishwashermustbeinstalledsothatdrainhoseisnomore than10feetinlengthforproperdrainage.

• Thedishwashermustbefullyenclosedonthetop,sidesand back,andmustnotsupportanypartoftheenclosure.

CLEARANCES : When

installedintoacorner, allow2"rain.clearance

betweendishwasherand adjacentcabinet,wallor otherappliances.Allow

25-5/8"min.clearance fromthefrontofthe

dishwasherfordoor opening.FigureB

/_ Countertop

25-5/8"

ClearanceforDoor

pening2"Minimum

PJ__re B

Note : ADAinstallation,[32-1/2'1beneath34"highcounter-topsmaybe accomplishedbyadjustingthetoehichandlevelinglegs.

Method 1 - Air Gap with Waste Tee or Ei_ °ser R _.___

_gure C

Method 2 - High Drain with Waste Tee or Disposer

Provideamethodtoattachdrainhosetoundersideofcounte_op.

in,

_Mlin--%..

CAUTION:

AnairgapMUSTBEUSEDif thedrainhoseisconnectedto wasteteeordisposerlowerthan18"abovethefloor.

Failuretoprovidetheproperdrainconnectionheightwithairgap or32"minimum,highdrainloopwillresultinimproperdraining

ofthedishwasher.

Pioure D

installwasteteeordisposerandairgapaccordingto manufacturer'sinstructions.

CABINET PREPARATION

• Drilla1-1/2"dia.holeinthecabinetwailwithintheshaded areasshowninFigureAforthedrainhoseconnection.Thehole shouldbesmoothwithnosharpedges.

Installation Preparation

PREPARE ELECTRICAL WIRING

FORPERSOHALSAFETY:Removehousefuse oropencircuitbreakerbeforebeginning

installation.Donotuseanextensioncordor

WARNING

adapterplugwiththisappliance.

Electrical Requirements

• Thisappliancemustbesuppliedwith120V,60Hz.,and

connectedtoanindividualproperlygroundedbranchcircuit, protectedbya15or20amperecircuitbreakerortimedelay

fuse.

• Wiringmustbe2wirewithground.

• iftheelectricalsupplydoesnotmeettheaboverequirements,

callalicensedelectricianbeforeproceeding.

Grounding Instructions - Cable Direct

Thisappliancemustbeconnectedtoagroundedmetal,permanent wiringsystem,oranequipmentgroundingconductormustberun withthecircuitconductorsandbeconnectedtotheequipment groundingterminalorleadontheappliance.

Grounding Instructions - Power Cord Models

hisappliancemustbegrounded,intheeventofamalfunctionor breakdown,groundingwillreducetheriskofelectricalshockby providingapathofleastresistanceforelectriccurrent.Theplug mustbepluggedintoanappropriateoutletthatisinstalledand groundedinaccordancewithlocalcodesandordinances.

WARNING

Theimproperconnectionoftheequipment groundingconductorcanresultinariskof electricshock.Checkwithaqualified electricianorservicerepresentativeifyou areindoubtthattheapplianceisproperly grounded.

/ I

1-1/2" Dia,

tole

PZguz_ E

Cabinet Preparation & Wire Routing

I \ I \

I x\

from

Cabinet

White

• Thewiringmayentertheopeningfromeitherside,rearorthe

floorwithintheshadedarea.

• Cuta1-1/2"max.dia.holetoadmittheelectricalcable.Thehole mustbefreeofsharpedges,if thecabinetwailismetal,the holeedgemustbecoveredwithabushing.

• Cabledirectconnectionsmaypassthroughthesameholeasthe drainhoseandhotwaterline,if convenient,if cabinetwailis metal,theholeedgemustbecoveredwithabushing. NOTE: Powercordswithplugmustpassthroughaseparate

hole.

Electrical Connection to Dishwasher

Electricalconnectionisontherightfrontofdishwasher.

• Forcabledirectconnectionsthecablemustberoutedasshown

inFigureE.Cablemustextendaminimumof24"fromtherear wall.

• Forpowercordconnections,installa3-pronggroundingtype receptacle.Thepower-supplyreceptaclefortheapplianceshall beinstalledinacabinetoronawailadjacenttothe undercounterspaceinwhichtheapplianceistobeinstalled.

+ 8 hidden pages