Frigidaire FGMO3067UD, FPMO3077TFA Installation Guide
BUILT-IN MICROWAVE INSTALLATION INSTRUCTIONS
1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other ammable vapors
and liquids in the vicinity of this or any other appliance.
Your new microwave oven has been designed to t a limited variety of cutout sizes to make
the job of installing easier. The rst step of your installation should be to measure your current
cutout dimensions and compare them to the cutout dimensions chart below for your model.
You may nd little or no cabinet work being necessary.
Important Notes to the Installer
1. Read all of the installation instructions before installing the microwave oven.
2. Remove all packing material from the oven compartments before connecting the electrical supply to the
microwave oven.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
5. The oven door may be removed to facilitate installation.
1. Carpentry
Refer to gure 2, 3, or 4 for the dimensions applicable to
your appliance and the space necessary to receive the
oven. The oven support surface may be solid plywood or
similar material, however, the surface must be level from
side to side and from front to rear.
2. Electrical Requirements
This appliance must be supplied with the proper voltage
and frequency, and it must be connected to an individual,
properly grounded branch circuit protected by a circuitbreaker or fuse.
Important Notes to the Consumer
Keep these instructions with your Owner's Guide for the
local electrical inspector's use and future reference.
IMPORTANT SAFETY INSTRUCTIONS
• Be sure your microwave oven is installed and
grounded properly by a qualied installer or service
technician.
• This microwave oven must be electrically grounded
in accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No.
70- latest edtion in the United States, or with CSA
Standard C22.1, Canadian Electrical Code, Part 1, in
Canada.
Electrical Requirements:
• A three-prong grounded outlet
• 120 V, 60 Hz, AC only
•
15 Amp electrical supply with a fuse or a circuit
breaker
•
15 Amp outlet duplex must be used
United States
and Canada
Stepping, leaning, or sitting on the door
of this microwave oven can result in serious injuries and
can also cause damage to the microwave oven.
• Never use your microwave oven for warming or hea-
ting the room. Prolonged use of the microwave oven
without adequate ventilation can be dangerous.
The electrical power to the microwave
oven must be shut off while line connections are being
made. Failure to do so could result in serious injury or
death.
Figure 1: 3-prong 15-Amp Grounded Outlet
PN A06823502 (2018.06)
English – pages 1-5
Español – páginas 6-10
Français – pages 11-15
BUILT-IN MICROWAVE INSTALLATION INSTRUCTIONS
2
3. Cabinet Installation
1. Unpack the microwave oven.
2. Find the two mounting screws included in the literature package.
3. Insert the oven into the cabinet opening.
4. Push the oven in and against the cabinet.
NOTES:
1. The base must be capable of supporting 155 pounds
(70 kg).
2. Allow at least 21" (53.3 cm) clearance in front of the
oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper
installation of the built-in oven. If the oven decorative
trim does not lie ush against the cabinet, or if noise
is heard on models, verify dimension G to assure
that it is the required depth.
A
Do not lift or manipulate the oven door handle
or the control panel.
Heavy Weight Hazard
• Use two or more people to move and install the
microwave oven.
• Failure to follow this instruction can result in injury
or damage to the unit.
2"
min
I
24" min
Outlet
Area
15 Amp
Circuit
B
MODEL A B C D
MODEL F G
Microwave Oven
All dimensions are in inches (cm).
C
H
2"
min
F
G
36" min
17-5/8"
required
distance
to oor
D
Figure 2: Microwave Only
PRODUCT DIMENSIONS
30 19-1/4 19-3/4
CUTOUT DIMENSIONS AND CABINET WIDTH
Min. Max. Min Min. Max. Min.
28 28-3/8 22 17-3/4 18 30-1/8
24-5/8 Microwave Oven
H
I
BUILT-IN MICROWAVE INSTALLATION INSTRUCTIONS
3
NOTES:
1. The base must be capable of supporting 155 pounds
(70 kg).
2. Allow at least 21" (53.3 cm) clearance in front of the
oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper
installation of the built-in oven. If the oven decorative
trim does not lie ush against the cabinet, or if noise
is heard on models, verify dimension G to assure
that it is the required depth.
A
C
H
2"
min
I
24" min*
Outlet
Area
15 Amp
Circuit
F
B
MODEL A B C D
Microwave Oven
MODEL F G
Microwave Oven
All dimensions are in inches (cm).
G
2"
min*
17-5/8"
36" min
required
distance
to oor
D
* See wall oven
installation instructions
for cutout dimensions
Figure 3: Microwave with Wall Oven
PRODUCT DIMENSIONS
30 19-1/4 19-3/4
CUTOUT DIMENSIONS AND CABINET WIDTH
Min. Max. Min Min. Max. Min.
28 28-3/8 22 17-3/4 18 30-1/8
24-5/8
H
I
BUILT-IN MICROWAVE INSTALLATION INSTRUCTIONS
4
NOTES:
1. The base must be capable of supporting 155 pounds
(70 kg).
2. Allow at least 21" (53.3 cm) clearance in front of the
oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper
installation of the built-in oven. If the oven decorative
trim does not lie ush against the cabinet, or if noise
is heard on models, verify dimension G to assure
that it is the required depth.
A
Outlet
Area
15 Amp
Circuit
B
C
3"
min
H
36"
17-5/8"
D
Figure 4: Microwave Under Counter Top
G
F
24" min
PRODUCT DIMENSIONS
MODEL A B C D
Microwave Oven
CUTOUT DIMENSIONS AND CABINET WIDTH
MODEL F G
Min. Max. Min Min. Max.
Microwave Oven
All dimensions are in inches (cm).
30 19-1/4 19-3/4
28 28-3/8 22 17-3/4 18
24-5/8
H
BUILT-IN MICROWAVE INSTALLATION INSTRUCTIONS
5
4. Install Mounting Screws
The microwave oven can tip when the
door is open. The mounting screws supplied with the
microwave oven must be installed to prevent tipping of
the microwave oven and injury to persons.
1. The mounting holes in the side trims may be used as
a template to locate the appliance mounting screw
holes (see gure 5).
2. Use the two screws supplied to x the appliance to
the cabinet.
Mounting Holes
6. Model and Serial Number Location
The serial plate is located along the interior side trim of
the oven and visible when the door is open.
When ordering parts for or making inquiries about your
microwave oven, always be sure to include the model
and serial numbers and a lot number or letter from the
serial plate.
Serial Plate
5. Minimum Cutout Overlap
28"
1-1/2"
min cutout
1/8"
Figure 7: Minimum cutout overlap
17-3/4"
min
cutout
15/16"
Figure 6: Serial Plate LocationFigure 5: Mounting Screw Holes
Before You Call for Service
Read the "Before You Call for Service Checklist" and the
"Operating Instructions" in your Use and Care Guide:
it may save you time and expense. The list includes
common occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to your Use and Care Guide for service phone
numbers.
Loading...