Frigidaire FFRS10C2Q10, FFRS08C3Q11, FFRS08C3Q10 Owner’s Manual

IGIDA! E

TABLE OF CONTENTS

Important Safety Instrucbons ............................. 2-3 Care and Cleaning .......................................... !0

Product Regrstratlon ............................................ 4 Energy Saving Ideas ........................................ 10

Normal Sounds ................................................ 4 Before You Call ........................................... 11

Air CondLtloner Features .................................... 5 Ha]or Apphance Limited Warranty ........................ 12

Operating Instructions ......................................... 5-10

www fr_g_daire com USA 1-800-944-9044 www fHg_datre ca

Canada 1-800-265-8352

This USE & CARE MANUAL provides specific operating instructions for your model, Use the room air conditioner only as instructed in this USE & CARE MANUAL These instructions are not meant to cover every possible condition and situation that

may occur, Common sense and caution must be practiced when installing, operating, and maintaining any appliance

The power supply cord with this air conditioner contains a current

deteeDondev cedes onedtoreducether skotheroppl anceReadproductlabolsforf,ammabH tyondo erwarn ngs

of fire. .................................................................................

Please refer to the section 'Operation of Current Device' for details.

In the event that the power supply cord is Prevent Accidents damaged, it cannot be repaired. It must be

replaced with a cord from the product To reduce the risk of fire, electrical shock, or injury to persons when using your air conditioner, manufacturer, follow basic precautions, including the following:

...................................................................... • Be sure the electrical service is adequate for the model you have chosen. This information

Avoid fire hazard or electric shock. Do not

Jse an extension cord or an adaptor plug. Do remove the screen completely before installation.

not remove any prong from the power cord. _ Be sure the air conditioner has been securely and correctly installed according to the

Grounding type wail receptacle

,/'I

.///'_/,_"IJ circumstances, cut,

#, grounding prong, /

Power supply cord receptacle you intend to use is not adequately grounded or protected by a time delay fuse with 3-prong grounding or circuit breaker, have a qualified electrician install the proper receptacle.

plug and current • Do not run air conditioner without outside protective cover in place. This could result in detection device mechanical damage within the air conditioner.

bypass theremove, or

Do not st ........ gasoline or other fi.... ble yap..... d liquids in the vicinity of this or any

can be found on the serial plate, which is located on the side of the cabinet and behind the

grille.

If the air conditioner is to be installed in a window, you will probably want to clean both sides of the glass first. If the window is a triple-track type with a screen panel included,

separate installation instructions provided with this manual. Save this manual and the installation instructions for possible future use in removing orreinstalling this unit.

• When handling the air conditioner, be careful to avoid cuts from sharp metal fins on front and rear coils.

The complete electrical rating of your new room air conditioner is stated on the serial plate. Refer to the rating when checking the electrical requirements.

• B..... the ai.... diti .... is properly grounded. To minimize shock and fire hazards,

proper grounding is important. The power cord is equipped with a three-prong grounding plug for protection against shock hazards.

• Your air conditioner must be used in a properly grounded wall receptacle. If the wall

For Your Safety

Electrical Information

..........................................................................................................................: D? Pse e.te.s_opcord adar_rp!ug...............................................................................................

DANGER! Avoid Serious Injury or Death

This air conditioner contains no user-serviceable parts. Always call an authorized Electrolux servicer for repairs. Do not insert or place fingers or objects into the air discharge area in the front of the unit. Do not start or stop the air conditioner by unplugging the power cord or turning off the power at the electrical box.

Do not cut or damage the power cord. If the power cord is damaged, it should only be replaced by an authorized Electrolux servicer. In the event of a malfunction (sparks, burning smetl, etc.), immediately stop the operation, disconnect the power cord, and carl an authorized

Electrotux servicer.

• Do not operate the air conditioner with wet hands.

• Do not pull on the power cord. , Do not drink any water that is drained from the air conditioner.

2 igh s e e ed

CAUTION! Avoid InjuW or damage to the unitor other property

• Provide occasiona_ ventilation during use. Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups or make units run excessively.

• Do not climb on or place objects on outdoor part of the unit.

• Do not hang objects off the unit. Do not place containers with liquids on the unit.

Turn off the air conditioner at the power source when it will not be used for an extended period of time.

• Periodically check the condition of the unit's installation accessories for any damage. Do not apply heavy pressure to the radiator fins of the unit.

• Operate the unit with air filter in place.

• Do not block or cover the intake grille, discharge area and outlet ports.

• Ensure that any electrical/electronic equipment is one yard away from the unit.

, Do not use or store flammable gases near the unit.

READ THIS SECTION BEFORE ATTEHPTING TO OPERATE AIR CONDITIONER.

Unit must be upright for one hour prior to operating.

Operation of Current

Device

Plug in & press RESET

The power supply cord contains a current device that senses damage to the power cord. To test your power supply cord do the following:

1. Plug in the Air Conditioner.

2. The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will notice a click as the RESET button pops out.

3. Press the RESET button. Again you will notice a dick as the button engages.

4. The power supply cord is now supplying electricity to the unit. (On some products this is also indi- cated by a light on the plug head).

, Do not use this device to turn the unit on or off.

" Always make sure the RESET button is pushed in for correct operation.

. The power supply cord must be replaced if it fails to reset when either the TEST button is pushed,

or it cannot be reset. A new one can be obtained from the product manufacturer.

. if power supply cord is damaged, it CANNOT be repaired, it MUST be replaced by one obtained

from the product manufacturer.

Product Registration Record Your Hodel and Serial Numbers

Record in the space provided below the model and serial numbers. On all models, the

serial plate is located on the outside of the cabinet.

Model No

Serial No

The self-addressed PRODUCT REGISTPJ_TION CARD should be filled in completely, signed and returned to the Frigidaire Company.

Normal Sounds

High pitched Chatter Today's high efficiency compressors

may have a high pitched chatter

Sound of t?ush/ng Air At the front of the unit, you may

hear the sound of rushing air being moved by the fan.

Gurgle/Hiss

"Gurgling or hissing" noise may be heard due to refrigerant passing through

evaporator during normal operation.

during the cooling cycle.

Vibration

Unit may vibrate and make noise because of poor wall or window construction or incorrect installation.

Pinging or Swishing

3lets of water hitting condenser

during normal operation may cause "pinging or swishing" sounds.

Note: Don't try to drill any holes on the base pan to eliminate the

normal sounds, otherwise it will void the warranty,

+ 8 hidden pages