FFRE1233S10
Installation Instructions
:
READ BEFORE INSTALLING UNIT
Compact Window Mounting (10,000~12,000 BTU)
The unit is for window mounting only.
Carefully read the installation manual before beginning.
Pay attention to danger and safety notices.
be exposed:
Carefully inspect location where air conditioner will be inst
period of time.
Handle air conditioner with care.
INSTALLATION WARNINGS AND CAUTION
NOTE
the best way to store unit during winter, or when not
in use.
The top rail on your unit may already be installed. If not,
follow the steps below.
Top Rail Hardware
Qty.
4
Top Rail
Before installing, the top rail must be assembled on the unit.
Top Rail
1
Mounting Hardware
( or Wooden windows)
weather stripping
(10”X3/4”X1/12”)
window sash seal foam 1
insulation panel
12
3
4
5
1
2
3
4
5
6
7
8
9
10
1
1
12
Drill (If pilot holes are needed)
ruler
Qty.
7
2
2
s)
1
5
2
1
16120300A04443
How to Install
Installation
LEFT + RIGHT FILLER PANEL ASSEMBLY
NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear of (5/16”).
This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels
for any reason, this pitch to the rear must be maintained!
Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper
panel for each side. When installed, the flange for securing the panel in place to the window sill will be facing
into the room.
A. Hold the side Panel in one hand and gently pull back the center to free the open end. See FIG. 1.
B. Slide the free end “ ” section of the panel directly into the cabinet as shown in FIG. 2. Slide the panel down. Be
sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet.
C. Once the panel has been installed on the side of the cabinet, make sure it sits securely inside the frame channel by
making slight adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. See
FIG. 3.
D. Slide the panel all the way in and repeat on the other side.
Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches
(584 mm to 914 mm) (FIG. 4A & FIG. 4B)
Lower sash must open sufficiently to allow a clear vertical opening of 15-1/2 inches (394 mm ). Side louvers and the
rear of the air conditioner must have clear air space to allow enough airflow through the condenser, for heat removal.
The rear of the unit must be outdoors, not inside a building or garage.
T
FIG. 2FIG. 1
“ ” section
T
FIG. 3
Top Rail
Bottom Rail
Fig. 4A
INNER
WINDOW SILL
INTERIOR
WALL
394 mm
Wooden Windows
Storm Window:
If the air conditoner is blocked by Storm Window, add wood as
shown in FIG. 5, or remove storm window before air conditioner
is installed.
If Storm Window Frame must remain, be sure the drain holes or
slots are not caulked or painted shut. Accumulated Rain Water
or Condensation must be allowed to drain out.
Fig. 4B
INNER
WINDOW SILL
Storm window
frame or other
obstruction.
SASH
1-1/2” min
(38 mm)
394 mm
Vinyl-Clad Windows
FIG. 5
Board
thickness as
required, for
proper pitch to
rear, along
entire sill.
Fasten with
nails or screws.
Loading...