F IGIDA! E
TABLE OF CONTENTS
Important Safety Instructions .............................. 2-3 Operating Instructions ....................................... 5-8
Product Registration ........................................ 4 Care and Cleaning ...................................... 9
Packaging ................................................... 4 Energy Saving Ideas ........................................ 9
Normal Sounds ............................................... 4 Before You Call .................................................. ]0
A_rConditioner Features ...................................... 5 Major Appliance Limited Warranty ........................ 11
www.fng_da_re.com USA 1-800-944-9044 www,fHgtdalre.ca Canada 1-800-265-8352
--a
o
v
This USE & CARE MANUAL provides specific operating instructions for your model Use the room air conditioner only as
instructed in this USE & CARE MANUAL These instructions are not meant to cover every possible condition and situation that
may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance.
The power supply cord with
this air conditioner contains a current
detection device designed to reduce the risk other appliance. Read product labels for flammability and other warnings.
of fire. ............................................................................
Please refer to the section 'Operation of
Current Device' for details.
In the event that the power supply cord is
damaged, it cannot be repaired. It must be Prevent Accidents
replaced with a cord from the product To reduce the risk of fire, electrical shock, or injury to persons when using your air conditioner,
manufacturer, follow basic p..... ti.... including the following:
...................................................................................................................................................................................• Be sure the electrical service is adequate for the model you have chosen. This information
Avoid fire hazard or electric shock. Do not
use an extension cord or an adaptor plug. Do remove the screen completely before installation.
not remove any prong from the power cord. ° Be sure the air conditioner has been securely and correctly installed according to the
................................... separate installation instructions provided with this manual. Save this manual and the
Grounding type wall installation instructions for possible future use in removing or reinstalling this unit.
receptacle , When handling the air conditioner, be careful to avoid cuts from sharp metal fins on front
This air conditioner contains no user-serviceable parts. Always call an authorized Electrolux servicer for repairs.
Do not insert or place fingers or objects into the air discharge area in the front of the unit.
Do not start or stop the air conditioner by unplugging the power cord or turning off the power at the electrical box.
Do net cut or damage the power cord.
If the power cord is damaged, it should only be replaced by an authorized Electrolux servicer.
In the event of a malfunction (sparks, burning smell, etc.), immediately stop the operation, disconnect the power cord, and call an authorized
Electrolux servicer.
o Do net operate the air conditioner with wet hands.
° Do not pull on the power cord.
* Do not drink any water that is drained from the air conditioner.
Do For Your Safety
not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
can be found on the serial plate, which is located on the side of the cabinet and behind the
grille.
, If the air conditioner is to be installed in a window, you will probably want to clean both
sides of the glass first. If the window is a triple-track type with a screen panel included,
DANGER! Avoid Serious Injury or Death
CAUTION. I Avoid Injury or damage to the unit or other property
• Provide occasional ventilation during use. Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups or make
units run excessivel%
Do not climb on or place objects on outdoor part of the unit.
Do not hang objects off the unit.
Do not place containers with liquids on the unit.
Turn off the air conditioner at the power source when it will not be used for an extended period of time.
Periodically check the condition of the unit's installation accessories for any damage.
Do not apply heavy pressure to the radiator fins of the unit.
Operate the unit with air filter in place.
Do not block or cover the intake grille, discharge area and outlet ports.
Ensure that any electrical/electronic equipment is one yard away from the unit.
Do not use or store flammable gases near the unit.
READ THIS SECTION BEFORE ATTEMPTING TO OPERATE AIR CONDITIONER,
Unit must be upright for one hour prior to operating.
Operation of Current
Device
Plug in & _.
press RESET
@
The power supply cord contains a current device that senses damage to the power cord. To test
your power supply cord do the following:
1, Plug in the Air Conditioner.
2, The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will
notice a click as the RESET button pops out,
8, Press the RESET button. Again you will notice a dick as the button engages,
4. The power supply cord is now supplying electricity to the unit,
. Do not use this device to turn the unit on or off.
: Always make sure the RESET button is pushed in f ........ t pperation.
The power supply cord must be replaced if it fails to reset when either the TEST button is pushed,
or it cannot be reset. A new one can be obtained from the product manufacturer.
• If power supply cord is damaged, it CANNOT be repaired. It MUST be replaced by one obtained
from the product manufacturer.
@2009 Electrolux Home Products, Inc, All rights reserved,
Product Registration Record Your Model and Serial Numbers
Record in the space provided below the model and serial numbers On all models, the
serial plate is located on the outside of the cabinet,
Model No.
Serial No
Register Your Product
The self-addressed PRODUCT REGISTRATION CARD should be filled in completely,
signed and returned to the Frigidaire Company,
Packaging Remove all packaging from inside the carton, along with any
inserts placed into the side louvers.
/
Normal Sounds
Sound of Rushing Air
At the front of the unit, you may
hear the sound of rushing air
being moved by the fan
Gurg/e/H/ss
"Gurgling or hissing" noise may be heard
due to refrigerant passing through
evaporator during normal operation
_-_
PACKAGING
High pitched Chatter
Today's high efficiency compressors
may have a high pitched chatter
during the cooling cycle
INSERTS
Vibration
Unit may vibrate and make noise
because of poor wall or window
construction or incorrect installation
Pinging or Swishing
,i
Droplets of water hitting condenser
during normal operation may cause
"pinging or swishing" sounds
Note; Don't try to drill any holes
on the base pan to eliminate the
normal sounds, otherwise it will
void the warranty.
j7