Frigidaire FFRA0511U10, FFRA0511U1E0, FFRA0511UE0, FFRA051ZA10, FFRA0522U10 Installation Guide

READ BEFORE INSTALLING UNIT

BT Window Mounting (5,000 BTU)

1

Installation Instructions

Before installing, the top rail must be assembled on the unit.

Top Rail Hardware

Qty.

4

1

Top Rail

Drill (If pilot holes are needed)

7

1

Mounting Hardware Qty.

2

(For Vinyl-Clad windows)

NOTE:

the best way to store unit during winter, or when not

in use.

2

(For Wooden windows)

Top Rail

Fig. C

weather seals

5

window sash seal foam 1

be exposed:

Carefully read the installation manual before beginning.

INSTALLATION WARNINGS AND CAUTION

Fig. B

Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over an extended

period of time.

66129926560

NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear. This is

necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any

reason, this pitch to the rear must be maintained!

Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper

panel for each side. When installed, the flange for securing the panel in place to the window sill will be facing

into the room.

A. Hold the side Panel in one hand and gently pull back the center to free the open end. See FIG. 1.

B. Slide the free end “T” section of the panel directly into the cabinet as shown in FIG. 2. Slide the panel down. Be

sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet.

LEFT + RIGHT FILLER PANEL ASSEMBLY

FIG. 2 FIG. 3FIG. 1

C. Once the panel has been installed on the side of the cabinet, make sure it sits securely inside the frame channel by

making slight adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. See

FIG. 3.

D. Slide the panel all the way in and repeat on the other side.

2

Installation

“T” section

Top Rail

Bottom Rail

Cut the seal foam(adherent type) into proper length. Then stick the seal foam at the lower part of the window frame.

Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches

(584 mm to 914 mm) (FIG. 4A & FIG. 4B)

Lower sash must open sufficiently to allow a clear vertical opening of 14.5 inches (368 mm ). Side louvers and the rear of

the air conditioner must have clear air space to allow enough airflow through the condenser, for heat removal. The rear

of the unit must be outdoors, not inside a building or garage.

SEAL FOAM

Fig. 4A

Wooden Windows

Fig. 4B

Vinyl-Clad Windows

INNER

WINDOW SILL

INNER

WINDOW SILL

INTERIOR

WALL

If the air conditioner is blocked by Storm Window, add wood as

shown in FIG. 5, or remove storm window before air conditioner

is installed.

If Storm Window Frame must remain, be sure the drain holes or

slots are not caulked or painted shut. Accumulated Rain Water

or Condensation must be allowed to drain out.

Storm Window:

FIG. 5

Board

thickness as

required, for

proper pitch to

rear, along

entire sill.

Fasten with

nails or screws.

Storm window

frame or other

obstruction.

SASH

1-1/2” min

(38 mm)

14.5" min

(368 mm)

14.5" min

(368 mm)

SEAL FOAM