Frigidaire FEQ332ES0, FEQ332ES - 27"" Electric Dryer, FGQ332ES - 27"" Gas Dryer Operating Instructions Manual
Select the temperature setting most suitable for
each load. The REGULAR--HIGH HEAT, PERM
PRESS--MEDIUM HEAT and DELICATES--LOW
HEAT temperature settings may be used with any
cycle setting.
Cycle Selection
Turn cycle selector clockwise to desired cycle and
setting.
The Automatic and Timed Dry cycles end with a
cool down period. The heat automatically turns off
and the load continues to tumble during the cool
down period. This reduces wrinkling and makes
items easier to handle during unloading.
Drying time varies depending on size and
dampness of load, weight and fabric type. Room
temperature and humidity, type of installation and
electrical voltage or gas pressure can also affect
drying time.
OPERATING INSTRUCTIONS
Before Operating Your Dryer
Read your dryer Use and Care Guide. It has
important safety and warranty information. It also
has many suggestions for best drying results.
To reduce the risk of fire, electric
shock, or injury to persons, read the IMPORTANT
SAFETY INSTRUCTIONS in your dryer Use and
Care Guide before operating this appliance.
Operating Steps
Read Drying Procedures in your Use and Care
Guide. It explains these operating steps in detail.
1. Prepare items for drying.
2. Check that lint screen is clean and in place.
3. Load the dryer. If desired, add a dryer fabric
softener sheet.
4. Close the dryer door.
5. Set Temperature and Cycle Signal controls.
6. Turn cycle selector clockwise to desired
setting.
7. Start dryer. Turn the Turn to Start control
clockwise to ON. Hold for 1-2 seconds and
release.
8. When Cycle Signal control is on, a signal
will sound at the end of the cycle.
9. Remove items immediately and hang or fold.
10. Clean lint screen after every load.
Temperature Selection
Always follow directions on fabric care
labels.
To avoid fire hazard, do not use
heat to dry items containing feathers or down, foam
rubber, plastics, or similarly textured, rubber-like
materials. Use the Air Fluff-No Heat cycle only.
Printed in U.S.A. P/N 134383600 (0401)
(continued, reverse side)
20
AUTOMATIC DRY
REGULAR/WHITES
30
COOL DOWN
60
10
DELICATES/PERM PRESS/COLORS
TIMED DRY
OFF
DAMP DRY
AIR FLUFF
NO HEAT
70
30
40
50
80
90
20
10
TOWELS
OFF
OFF
OFF
TEMPERATURE
MEDIUM HEAT
HIGH HEAT
LOW HEAT
CYCLE SIGNAL
ON
OFF
START
ON
COOL DOWN
P/N 134383600 (0401)
• DAMP DRY - This setting is best for items you
wish to partially dry before hanging or ironing.
Select the temperature setting most suitable for
the load.
Air Fluff Cycle
This cycle provides up to 30 minutes of tumbling
without heat. Use AIR FLUFF to dry items
containing feathers or down, foam rubber, plastics,
or similarly textured, rubber-like materials, to
freshen clothing, pillows or blankets, or to dust
draperies.
Timed Dry Cycle
This cycle provides up to 80 minutes of drying time
at the temperature selection of your choice.
Energy Saving Tips
• Keep the lint screen clean and exhaust the dryer
correctly.
Automatic Cycle
• TOWELS - This setting is best for towel loads.
Select the REGULAR--HIGH HEAT temperature
setting.
• REGULAR - This setting is best for cotton items.
Select the REGULAR--HIGH HEAT temperature
setting.
• DELICATES/PERM PRESS - This setting is best
for delicate or perm press items. Select the
PERM PRESS--MEDIUM HEAT temperature
setting for permanent press items, or the
DELICATES--LOW HEAT temperature setting for
delicate items.
• Occasionally a load may seem too damp or
overdried at the end of the cycle. To increase
drying time for similar loads in the future, set the
cycle selector on the indicator line to the left of
the TOWELS, REGULAR, or DELICATES/PERM
PRESS setting. For loads requiring less drying
time, set the cycle selector on the indicator line to
the right.
Cycle Selection (continued)
• Sort laundry properly and select proper
temperature and cycle settings. Choose the
Automatic cycle whenever possible for accurate
drying time.
• Dry only full loads. Single items and small loads
usually take longer to dry.
• Avoid overloading, adding wet items to a partially
dry load, and overdrying.
• Dry one load after another to take advantage of a
warm dryer.
• Opening the door needlessly causes warm air to
escape, which prolongs drying time.
• If possible, use the dryer on low humidity days.
• Install the dryer in an area where the room temperature
is at least 45°F (7°C).
20
AUTOMATIC DRY
REGULAR/WHITES
30
COOL DOWN
60
10
DELICATES/PERM PRESS/COLORS
TIMED DRY
OFF
DAMP DRY
AIR FLUFF
NO HEAT
70
30
40
50
80
90
20
10
TOWELS
OFF
OFF
OFF
TEMPERATURE
MEDIUM HEAT
HIGH HEAT
LOW HEAT
CYCLE SIGNAL
ON
OFF
START
ON
COOL DOWN
Loading...