Frigidaire FAK085P7V1, FAK107P1V1 Installation Guide

I tallati i structi

for ider Casement

NOTE: These instructions describe installation

in a typical wood framed window with a wood
SLIDE-BY sash, or installation in a metal

CASEMENT window. Modification may be
necessary when installing in windows made

differently than those shown in these instructions.
Ahigh window accessory kit EA 103W is available

for window heights up to 62"(1575mm).

Meeting Electrical Requirements

TABLE OF CONTENTS

SUBJECT PAGE
Meeting Electrical Requirements 1

Electrical Connection 2
Preparing for Installation 2

Sliding Window Installation 4
Casement Window Installation 5

Installation in Wood Window 6

OBSERVE ALL LOCAL GOVERNING CODES

AND ORDINANCES.

DO NOT, UNDERANY CIRCUMSTANCES, REMOVE

THE POWERSUPPLYCORDGROUNDINGPRONG.

NOTE: If codes permit, and a separate grounding

wire is used; it is recommended that a qualified
electrician determine that the grounding path is

adequate and not interrupted by plastic, non-metallic
gaskets, orother insulating materials.

RECEPTACLE WIRING
Receptacle wiring should bea minimumof 14gauge.

Use copper wire only. It is your responsibility to
provide proper and adequate receptacle wiring,

installed bya qualified electrician.

ELECTRICAL REQUIREMENTS
A 115 volt (103minimum, 126maximum), 60Hertz,
AC only, 15 ampere fused electrical supply is

required. A time delay fuse or time delay circuit

breaker is also required. A separate circuit, serving
only this appliance, MUSTbe provided.

P/N

ili

Electrical Connection

Electrical ground is required on this appliance.

Recommended grounding method:

For your personal safety, thisappliancemustbe
grounded. This air conditioner includes a power
supply cord with a 3-prong grounding plug. To
minimize possible electrical shock hazard:

-cord must be plugged into a mating 3-prong
grounding-type wall receptacle,

-must be grounded in accordance with
National Electrical Code (ANSI/NFPA70-

latest version) and

-all local codes and ordinances.

If a mating 3-prong grounding-type wall
receptacle is not available, it is the responsibility

of the consumer to have a properly grounded
3-prong wall receptacle installed by a qualified

electrician.

NOTE: Adamaged powersupply cord CANNOT be
repaired-it MUST be replaced with a new power
supply cord obtained from the product

manufacturer.

Avoid fire hazard or

electric shock. Do notuse an extension
cord or an adaptor plug. Do not remove

any prong from the power cord.

Grounding type wall
receptacle

circumstances, cut,

/ remove, or bypass /

__ _DDo not, under an_yy

Power supply cord
with 3-prong grounding
plug and current

detection device

_he gr°unding Pr°_

NOTE: The rating plate on the unit contains
electrical and other technical data. The rating
plate is located on the right side of the unit.

Preparing for Installation

Installation Tips

For wood-frame casement windows: It may be

necessary to construct a frame, using at least

1-inch thick wood, with a 15-1!2-inch wide

opening.

For brick or cement building construction: It

may be necessary to put awood stool strip under

AC, for mounting purposes.

Tools

Required

®

Flat-head screwdriver

®

Phillips-head screwdriver

tl

Carpenter's level

®

Tape measure

®

Fine tooth saw

II

Electric orhand drill

II

Knife and scissors

o

Pencil

--2--