Frigidaire FAD504TDB2, FAD504TDB3, FAD504TDB5, FAD704TDB4, FAD704TDB7 Owner’s Manual

ii!ii!iliiii!iiii ii_I:I_i_ i

Operating Instructions ..................

iiiiiiiii!i!ili!!li_!iiii!iiiii_iYiiiiiiiiiiii/Iiliiiiiiiiiii!ii

TAB

_a_%,............

>

www.frigidaire.com USA 1-800-944-9044 www.frigidaire.ca Canada 1-800-265-8352

This USE & CARE MANUAL provides specific operating instructions for your model. Use the room air conditioner only as instructed in this USE&
CARE MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution

must be practiced when installing, operating, and maintaining any appliance.

For Your Safety

, Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or

any other appliance. Read product labels for flammability and other warnings.

= Discard water from bucket. Water is not potable and cannot be used for drinking.

Grounding type wall
receptacle

Child Safety Precautions

• Destroy the carton, plastic bags, and any packing materials immediately after the

dehumidifier is unpacked. Children should never use these items for play.

Do not leave children unattended in an area where the appliance is operating.

Power supply cord II

with 3-prong grounding

plug

Location

/

\

Electrical Information

• For your safety and protection, this dehumidifier is equipped with a three-prong grounding
plug on the power cord. Do not, under any circumstances, cut or remove the round ground
prong from the plug.

, Your dehumidifier must be plugged directly into a properly grounded and polarized

three-prong receptacle. If the wall receptacle you intend to use will not accept a
three-prong plug, or if you are not sure the outlet is adequately grounded or protected

by a time delay fuse or circuit breaker, have a qualified electrician install the proper outlet
according to the National Electrical Code and applicable local codes and ordinances. Do not

ii

use an extension cord or an adapter plug.

° Never unplug the dehumidifier by pulling on the power cord. Always grip the plug firmly

and pull straight out from the receptacle.

ii

• DOnot pinch, bend, or knot the power cord.

Selecting a Location

IMPORTANT:

1.Dehumidifiermust be operatedinan enclosedareato be most effective.Closealldoors,
windows, and otheroutsideopeningsto theroom. The effectivenessofthe dehumidifier

depends on the rate at which new moisture-laden air enters the room.

2. Place dehumidifier in a location that does not restrict airflow through the front of the unit or
out of the louvers on the left side of cabinet.

3. A dehumidifier operating in a basement will have little or no effect in drying an adjacent

enclosed storage area, such as a closet, unless there is adequate circulation of air in and out
of the area. It may be necessary to install a second dehumidifier in the enclosed area for

satisfactory drying.

4. The dehumidifier must be installed on a level floor that will support it with a full bucket of
water.

5. There should be a minimum of 12 inches clearance around the dehumidifier.

How It Works

©2009 Electrolux Home Products, Inc. All rights reserved.

When the unit is started, the fan begins to pull moisture-laden air across the dehumidifying coils.
The coils condense or draw moisture from the air, and air flows through the side louvers into the

room as dry, warm air. Moisture removed from air is collected in a bucket on the front of the
dehumidifier.

The unit is designed to operate between 41 °F (5 °C), and 96 °F(35 °C).
The "Compressor" circuit has an automatic 3 minute time delayed start if the unit is turned off

and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping.

Make sure the tank is fitted correctly otherwise unit will not turn on.

Operating Instructions

Allow the unit to reach room temperature before operating,

To begin operating the dehumidifierr follow these steps:

Unit must be upright for one hour prior to operating.

1. Plug the power cord into a properly grounded 115 volt AC outlet. The POWER indicators will illuminate.

Tfthe "BUCKET FULL" light is on, remove the bucket and re-install to reset the float switch.

HUMIDITY SETTING

HIGH

BUCKET FULL 0

ON LOW

RH% FILTERRESET POWER

@@

_. HUMIDITY

2. To turn the unit on press the ON/OFF button. The unit will run in the factory setting of CONTINUOUS and high fan speed.
In the Continuos Mode the unit will only display CO and not the room humidity. It is recommended you leave the unit

running in the CONTINUOUS setting for the first three or four days until the sweating and dampness odors have stopped.

HUMIDITY SETTING

HIGH W BUCKET FULL

®

0 N LOW

RH% FILTERRESET POWER

J

@2009 Electrolux Home Products, Inc. All rights reserved.