Frigidaire CRA093PT113, CRA113PT111, CRA11EPT110, CRA113PT110, CRA12EPT10 Owner’s Manual

...

FRIGIDAIRE

u iii

Prod Normal Sound

Installation II

Www:frigidaireiCOm [-800_265_8352

This USE & CARE MANUAL provides specific operating instructions for your model. Use the room air conditioner only as instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that

mayoccur.Commonsenseandcautionmustbepracticedwheninsta,ing,operating,andmaintaininganyappliance.

The power supply cord with this air conditioner contains a current detection device designed to reduce the risk

of fire. Please refer to the section 'Operation of

Current Device' for details. tn the event that the power supply cord is damaged, it cannot be repaired, tt must be

replaced with a cord from the product manufacturer.

Avoid fire hazard or electric shock. Do not

use an extension cord or an adaptor plug. Do not remove any prong from the power cord.

Grounding type wall receptacle

Do not, under anY_

A_. ;;_ circumstances, cut,

remove,orbypassthe; ....

Power supply cord with 3-prong grounding

plug and current detection device

To reduce the risk of fire, electrical shock, or injury to persons when using your air conditioner, follow basic precautions, including the following:

Be sure the electrical service is adequate for the model you have chosen. This information

can be found on the serial plate, which is located on the side of the cabinet.

If the air conditioner is to be installed in a window, you will probably want to clean both

sides of the glass first.

Be sure the air conditioner has been securely and correctly installed according to the installation instructions in this manual. Save this manual for possible future use in removing or reinstalling this unit.

The complete electrical rating of your new protable air conditioner is stated on the serial plate. Refer to the rating when checking the electrical requirements.

• Be sure the air conditioner is properly grounded. To minimize shock and fire hazards, proper grounding is important. The power cord is equipped with a three-prong grounding

plug for protection against shock hazards.

• Your air conditioner must be used in a properly grounded wall receptacle. If the wall receptacle you intend to use is not adequately grounded or protected by a time delay fuse

. or circuit breaker, have a qualified electrician install the proper receptacle.

Do not run air conditioner without outside protective cover in place. This could result in mechanical damage within the air conditioner.

• Do not use an extension cord or an adapter plug.

Prevent Accidents

Electrical Information

READ THIS SECTION BEFORE ATTEHPTING TO OPERATE AIR CONDITIONER,

Unit must be upright for one hour prior to operating.

Operation of Current

Device

Plug in & press RESET

The power supply cord contains a current device that senses damage to the power cord. To test

your power supply cord do the following:

1. Plug in the Air Conditioner.

2. The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will notice a click as the RESET button pops out.

3. Press the RESET button, Again you will notice a click as the button engages.

4. The power supply cord is now supplying electricity to the unit, (On some products this is also indi- cated by a light on the plug head),

, Do not use this device to turn the unit on or off.

• Always make sure the RESETbutton is pushed in for correct operation.

• The power supply cord must be replaced if it fails to reset when either the TEST button is pushed, or it cannot be reset. A new one can be obtained from the product manufacturer.

, If power supply cord is damaged, it CANNOT be repaired, It MUST be replaced by one obtained

from the product manufacturer.

Product Registration Record Your Hodei and Serial Numbers

Record in the space provided below the model and serial numbers. On all models, the

serial plate is located on the side of the cabinet.

Hodel No,

Serial No

The self-addressed PRODUCT REGISTRATION CARD should be filled in completely, signed and returned to the Frigidaire Company.

Normal Sounds

Sound of Rushing Air

At the front of the unit, you may

hear the sound of rushing air being moved by the fan.

H!gh pitched Chatter

Today'shigh efficiency compressorsmayhavea high pitched chatter during the cooling cycle.

Gurgle/Hiss

"Gurgling or hissing" noise may be

heard due to refrigerant passing

through evaporator during normal

operation.

Vibration

Unit may vibrate and make noise because of uneven floor,

Unit Description

CONTROL PANEL

CARRYING HANDLE

(BOTH SIDES)

REMOTE CONTROL STORAGE DOOR

REMOTE CONTROL

Accessories Included

ROOM AIR DISCHARGE

Fig, 1

EXHAUST AIR OUTLET

EXHAUST

ADAPTOR A

AIR INTAKE

DEHUMIDIFYING DRAIN OUTLET

EXHAUST HOSE

(STORAGE WHEN

NOT IN USE)

BOTTOM TRAY DRAIN OUTLET

PARTS: PARTS NAHE: QUANTITY:

Exhaust hose 1 pc

Exhaust A 1

Unit/ Adaptor pc

Window/Exhaust Adaptor B 1 pc

Window Sliding Kit 1 set

Foam Seal

Remote Control 1 pc

Battery(For control) pcs

remote

3 pcs

Fig, 2

• Check all the accessories are included in the package and please refer to the installation instructions for their usage.

+ 8 hidden pages