Frigidaire CFGF337ESC, CFGF337ESD, CFGF337GSA, CFGF337GSB, CFGF366DBB Installation Guide

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

If the information in this manual is not followed

exactly, a fire or explosion may result causing property
damage, personal injury or death.

FOR YOUR SAFETY:
m Do not store or use gasoline or other flammable vapors

and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone
in your building.

• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire
department.

Installation and service must be performed by a qualified
installer, service agency or the gas supplier.

OVERALL

DIMENSIONS 253/4"

_--- 29-7/8" --_

*Minimum to -- 30"
Side Wall Minimum '_ Minimum to

47-3/4"

Maximum 36 _+1/8"

Side of Either Side
on Either "5"-_ /_ 1'8_"Cabinets on

Range 5" _..... _L,,__, of Range.

®® ® ®®

Refer to your serial plate for

applicable agency certification

• ALL RANGES
CAN TIP

• INJURY TO PERSONS
COULD RESULT

• INSTALL ANTI-TIP
DEVICE PACKED WITH
RANGE

• SEE INSTALLATION
INSTRUCTIONS

Note. For appfiances installed in the
State of Massachusetts see page 2.

FRONT

VIEW

SlIE

1-13"-1

for Cabinets

Maximum Depth !_

Above Range Top.

Jl_r JL_l,L Jl_rJL_l,L

44 5/8" _ |

\

Door Open ,, 29 7/8"I'''_>

Clearances and Dimensions

1. Location--Check location where
the range will be installed. Check

for proper electrical and gas
supply, and the stability of the

floor.

2. Dimensions that are shown must
be used. Given dimensions

provide minimum clearance.
Contact surface must be solid

and level.

pin 316259337 EN_FR (0408)

l T

36"

l

I'_- 30 1/8" _1 0" Clearance Below Cooking Top and at Rear of Range.

Provide Proper Fuel Type

Before Proceeding: Your range is preset to operate on natural gas only. This
model was shipped convertible from the factory with the necessary parts and
conversion instructions supplied.

DO NOT attempt to convert this range to LP/Propane settings without

the proper LP/Propane conversion kit provided with the range or obtained from your
dealer. Follow all instructions provided with this conversion kit.

Fran_ais - Pages 9-16

Important Notes to the Installer

1. Read all instructions contained in these installation
instructions before installing range.

2. Remove allpacking material from the oven compartments
before connecting the gas and electrical supply to the
range.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumer.

Important Note to the Consumer

1. Keep these instructions with your Use & Care Guide for
future reference.

IMPORTANT

SAFETY INSTRUCTIONS

Installation of this range must conform with local codes or, in
the absence of local codes, with the National Fuel Gas Code

ANSI Z223.1--1atest edition when installed in the United

States.

When installed in a manufactured (mobile) home, installation
must conform with the Manufactured Home Construction and

Safety Standard, Title 24 CFR, Part 3280 [formerly the
Federal Standard for Mobile Home Construction and Safety,
Title 24, HUD (Part 280)] or, when such standard is not
applicable, the Standard for Manufactured Home Installations,

ANSI/NCSBCS A225.1, or with local codes.

This range has been design certified by CSA International. As

with any appliance using gas and generating heat, there are

certain safety precautions you should follow. You will find
them in the Use & Care Guide, read it carefully.

• Be sure your range is installed and grounded properly
by a qualified installer or service technician.

• This range must be electrically grounded in

accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No .70--

latest edition when installed in the United States.

See Grounding Instructions on page 5.

• Before installing the range in an area covered with

linoleum or any other synthetic floor covering, make

sure the floor covering can withstand heat at least
90°F above room temperature without shrinking,
warping or discoloring. Do not install the range over

carpeting unless you place an insulating pad or sheet of

1/4-inch thick plywood between the range and carpeting.

• Make sure the wall coverings around the range can

withstand the heat generated by the range.

• Do not obstruct the flow of combustion air at the

oven vent nor around the base or beneath the lower

front panel of the range. Avoid touching the vent
openings or nearby surfaces as they may become hot
while the oven is inoperation. This range requires fresh air
for proper burner combustion.

Never leave children alone or unattended

in the area where an appliance is in use. As children grow,
teach them the proper, safe useof allappliances. Never leave
the oven door open when the range is unattended.

Stepping, leaning or sitting on the doors

or drawers of this range can result in serious injuries and
can also cause damage to the range.

• Do not store items of interest to children in the
cabinets above the range. Children could be seriously

burned climbing on the range to reach items.

• To eliminate the need to reach over the surface

burners, cabinet storage space above the burners
should be avoided.

• Adjust surface burner flame size so it does not
extend beyond the edge of the cooking utensil.

Excessive flame is hazardous.

• Do not use the oven as a storage space. This creates
a potentially hazardous situation.

• Never use your range for warming or heating the

room. Prolonged use of the range without adequate
ventilation can be dangerous.

• Do not store or use gasoline or other flammable
vapors and liquids near this or any other appliance.

Explosions or fires could result.

• Reset all controls to the "off" position after using a

programmable timing operation.

FOR MODELS WITH SELF-CLEAN FEATURE:

• Remove broiler pan, food and other utensils before
self-cleaning the oven. Wipe upexcess spillage. Follow

the cleaning instructions in the Use & Care Guide.

• Unlike the standard gas range, THIS COOKTOP IS
NOT REMOVABLE. Do not attempt to remove the
cooktop.

Special instructions for appliances installed in the State of
Massachusetts: This appfiance can only be installed in the
State of Massachusetts by a Massachusetts licensed

plumber or gas fitter. When using a flexible gas connector,
it must not exceed 3 feet (36 inches) in length. A "T" handle

type manual gas valve must be installed in the gas supply
line to this appliance.

DO NOT MAKE ANY ATTEMPT TO

OPERATE THE ELECTRIC IGNITION OVEN DURING AN

ELECTRICAL POWER FAILURE. RESET ALL OVEN

CONTROLS TO "OFF" IN THE EVENT OF A POWER

FAILURE.

The electric ignitor will automatically re-ignite the oven
burner when power resumes if the oven thermostat control

was left in the "ON" position.

When an electrical power failure occurs during use, the
surface burners will continue to operate.

During a power outage, the surface burners can be lit with

a match. Hold a lighted match to the burner, then slowly turn
the knob to the LITE position. Use extreme caution when

lighting burners this way.

Before Starting

Tools You Will Need

For leveling legs and Anti-Tip Bracket:

• Adjustable wrench or channel lock pliers

• 5/16" Nutdriver or Flat Head Screw Driver

• Electric Drill & 1/8" Diameter Drill Bit (5/32" Masonry Drill
Bit if installing in concrete)

For gas supply connection:

• Pipe wrench

For burner flame adjustment:

• Phillips head _ and
blade-type screwdrivers

For gas conversion (LP/Propane or Natural):

• Open end wrench - 1/2"

Additional Materials You Will Need

• Gas line shut-off valve

• Pipe joint sealant that resists action of LP/Propane gas

• A new flexible metal appliance conduit (1/2" NPT x 3/4"
or 1/2"1.D.) must be design certified by CSA International.

Because solid pipe restricts moving the range we
recommend using a new flexible conduit (4 to 5 foot

length) for each new installation and additional
reinstallations.

A.

Locate the Bracket Using the Template- (Bracket may
be located on either the left or right side of the range. Use
the information below to locate the bracket if template is
not available). Mark the floor or wall where left or right
sideoftherangewillbelocated. If rear of range isagainst
thewall or no further than 1-1/4" from wall when installed,
you may use the wall or floor mount method. If molding

is installed and does not allow the bracket to fit flush
against the wall, remove molding or mount bracket to the

floor. For wall mount, locate the bracket by placing the

back edge of the template against the rear wall and the
side edge of template on the mark made referencing the
side of the range. Place bracket on top of template and
mark location of the screw holes in wall. If rear of range
is further than 1-1/4" from the wall when installed, attach

bracket to the floor. For floor mount, locate the bracket
by placing back edge of the template where the rear of

the range will be located. Mark the location of the screw
holes, shown in template.

S .........

a.

Drill Pilot Holes and Fasten Bracket - Drill a 1/8" pilot
hole where screws are to be located. If bracket is to be

mounted to the wall, drill pilot hole at an approximate 20°
downward angle, tf bracket is to be mounted to masonry
or ceramic floors, drill a 5/32" pilot hole 1-3/4" deep. The
screws provided may be used in wood or concrete

material. Use a 5/16" nut-driver or flat head screwdriver
to secure the bracket in place.

• Always use the (2) new flare union adapters (1/2" NPT x
3/4" or 1/2" I.D.) supplied with the new flexible appliance
conduit for connection of the range.

Normal Installation Steps

1. Anti-Tip Bracket Installation Instructions

Important Safety Warning

To reduce the risk of tipping of the range, the range must be
secured to the floor by properly installed anti-tip bracket and
screws packed with the range. Failure to install the anti-tip
bracket will allow the range to tip over if excessive weight is
placed on an open door or if a child climbs upon it. Serious
injury might result from spilled hot liquids or from the range

itself.
If range is ever moved to a different location, the anti-tip

brackets must also be moved and installed with the range.
Instructions are provided for installation in wood or cement

fastened to either the floor orwall. When installed to the wall,

make sure that screws completely penetrate dry wall and are
secured inwood or metal. When fastening to the floor or wall,
be sure that screws do not penetrate electrical wiring or
plumbing.

FASTEN BRACKET (WALL OR FLOOR MOUNTING)

_i 1_1-1/4" Max.

Leveling Leg --

dr- Wall Mount

Floor Mount -----'_ L-Anti-Tip Bracket

FASTEN BRACKET (FLOOR MOUNTING ONLY)

More Than

Leveling Leg _ T_ 1-1/4"

Floor Mount _ Anti-Tip Bracket