Frigidaire 318201725 User Manual
30" Electric Range Installation Instructions
76,2 cm
(30”)
75,9 cm
(29-7/8”)
65,4 cm
(25-3/4”)
124,5 cm
(49”)
Maximum
116,8 cm (46”)
Door open
91,4 ± 0,3 cm
(36 ± 1/8”)
FRONT
VIEW
TYPICAL CABINET INSTALLATION
SIDE
VIEW
2,5 cm (1”)
Minimum to wall on
either side of range
above 91,4 cm (36”) height.
76,2 cm (30”)
Minimum*
76,2 cm
(30”)
45,7 cm (18”)
Minimum to cabinets
on either side of range
33 cm
(13”)
Maximum depth
for cabinets
above range top
0 cm (0”) clearance below cooking top and rear of range.
76,5 cm
(30 1/8”)
91,4 cm
(36”)
United States
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
Canada
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance.
1. Clearances and Dimensions
a. Provide adequate clearances between the range and adjacent combustible surfaces.
b. Location—Check location where the range will be installed. Check for proper electrical supply and the stability of floor.
c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must
be solid and level.
FRONT
VIEW
* 76,2 cm (30") minimum clearance between the top of the cooking
surface and the bottom of an unprotected wood or metal cabinet;
or 61 cm (24") minimum when bottom of wood or metal cabinet is
protected by not less than 0,64 cm (¼") flame retardant millboard
covered with not less than no. 28 MSG sheet steel, 0,038 cm
(0,015") stainless steel, 0,061 cm (0,024") aluminum or 0,051 cm
(0,020") copper. The minimum clearance is 0 cm (0") for the rear
of the range. Follow all dimension requirements provided above
to prevent property damage, potential fire hazard, and incorrect
countertop and cabinet cuts.
Avoid locating cabinet storage space above the surface units
to eliminate the possibility of cabinets catching on fire, or
personal burns from reaching for the cabinets over the heated
units. If cabinet storage is to be provided, risk can be reduced by
installing a range hood that projects horizontally a minimum of
5" beyond the bottom of the cabinets.
Important Notes to the Installer
1. Read all instructions contained in these installation instructions
2. Remove all packing material before connecting the electrical
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
Printed in United States
before installing the appliance.
supply to the appliance.
BACK
VIEW
Important Note to the Consumer
Keep these instructions with your Use and
Care Guide for future reference.
318201725 (0904) Rev. A
1
30" Electric Range Installation Instructions
CAUTION
2. Install Anti-Tip Bracket
IMPORTANT SAFETY WARNING
To reduce the risk of tipping of the range, the range
must be secured to the floor by properly installed antitip bracket and screws packed with the range. These
parts are located in a plastic bag in the oven. Failure
to install the anti-tip bracket will allow the range to tip
over if excessive weight is placed on an open door or
if a child climbs upon it. Serious injury may result from
spilled hot liquids or from the range itself. Refer to the
instructions located in the anti-tip bracket package for
proper bracket installation. If the range is moved to
a different location, the anti-tip bracket must also be
moved and installed with the range.
For the bracket installation instructions, refer to
the anti-tip bracket template shipped in the anti-tip
bracket package.
3. Serial Plate
Information
The serial plate
is located as
shown below. See
the serial plate
for the following
information:
A. Model, lot and
serial number of
range.
B. Kilowatt
rating (power
requirements).
C. Voltage ratings.
5. Leveling the Range
A. Install an oven rack in the center of the oven.
B. Place a level on the rack (see Figure 2). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leg levelers with a
wrench (see Figure 3).
Figure 2
Leg
Leveler
Raise
4. Electrical Connection Requirements
Plug the range cable (4 conductors) into a 4 conductor range outlet. Outlet must be properly grounded and
in accordance with the Canadian Electrical Code (CSA
Standard (C22.1 Part 1 -- latest edition) -- and any local
electrical code requirements.
Figure 1
4 Conductors Range Cable
Lower
Figure 3
6. Checking Operation
Refer to the Use and Care Guide for operation.
Do not touch cooktop glass or elements.
They may be hot enough to burn you.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of
defective workmanship or materials in this appliance.
2
Loading...